NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Kingston Technology Corp.
64 GB DDR5-6400 ECC registered dual-rank module with CL52 latency and 1.10 V operation for server motherboards
This 64GB DDR5 kit contains eight 8GB modules running at 6400 MT/s with CL52 latency. Registered signal processing and on-die ECC protect data integrity in multi-socket servers and workstations. The 1.10V operating voltage matches the DDR5 baseline for dense configurations. Modules use Hynix 2Rx4 ICs on standard 288-pin DIMM PCBs.
Registered buffering and the low 1.10V rail keep per-module power modest even with eight ranks populated. Passive operation is typical in chassis with directed airflow; no heat spreaders are fitted. The tRAC of 32ns and 52-52-52 timings indicate standard JEDEC DDR5-6400 behaviour under sustained server loads.
Registered clock drivers reduce electrical load on the memory controller, allowing all eight DIMM slots to be filled without signal degradation. On-die ECC corrects single-bit errors inside each DRAM chip before data leaves the module. The combination targets uptime-critical workloads rather than low-latency desktop or overclocking use.
| Brand | Kingston |
|---|---|
| Model | KSM64R52BD4-64HA |
| Capacity | 64GB (8 x 8GB) |
| Type | 288-Pin DDR5 SDRAM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Timing | 52-52-52 |
| tRAC | 32ns |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Hynix Chipset |
| Heat Spreader | No |
| Lähetyspaino | 0.05 kg |
| Pakkauksen mitat | 161 × 44 × 9 mm |
Align the notch on the module with the key in the server motherboard slot, press firmly until both retaining clips lock, then verify in BIOS that ECC and registered mode are enabled for the 2Rx4 configuration.
No scheduled maintenance is required; the modules have no heat spreader and run at 1.10V, so replacement is only necessary if a DIMM fails or the platform is upgraded beyond DDR5-6400.
The CL52 latency at 6400 MT/s sets the throughput ceiling; sustained workloads will hit bandwidth limits before thermal throttling because the modules operate at 1.10V without a spreader.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?