NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Kingston Technology Corp.
64 GB DDR5-6400 ECC registered dual-rank module with CL52 latency and 1.10 V operation for server motherboards
This 64GB DDR5 kit contains eight 8GB modules running at 6400 MT/s with CL52 latency. Registered signal processing and on-die ECC protect data integrity in multi-socket servers and workstations. The 1.10V operating voltage matches the DDR5 baseline for dense configurations. Modules use Hynix 2Rx4 ICs on standard 288-pin DIMM PCBs.
Registered buffering and the low 1.10V rail keep per-module power modest even with eight ranks populated. Passive operation is typical in chassis with directed airflow; no heat spreaders are fitted. The tRAC of 32ns and 52-52-52 timings indicate standard JEDEC DDR5-6400 behaviour under sustained server loads.
Registered clock drivers reduce electrical load on the memory controller, allowing all eight DIMM slots to be filled without signal degradation. On-die ECC corrects single-bit errors inside each DRAM chip before data leaves the module. The combination targets uptime-critical workloads rather than low-latency desktop or overclocking use.
| Brand | Kingston |
|---|---|
| Model | KSM64R52BD4-64HA |
| Capacity | 64GB (8 x 8GB) |
| Type | 288-Pin DDR5 SDRAM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Timing | 52-52-52 |
| tRAC | 32ns |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Hynix Chipset |
| Heat Spreader | No |
| Težina pošiljke | 0.05 kg |
| Dimenzije pakiranja | 161 × 44 × 9 mm |
Align the notch on the module with the key in the server motherboard slot, press firmly until both retaining clips lock, then verify in BIOS that ECC and registered mode are enabled for the 2Rx4 configuration.
No scheduled maintenance is required; the modules have no heat spreader and run at 1.10V, so replacement is only necessary if a DIMM fails or the platform is upgraded beyond DDR5-6400.
The CL52 latency at 6400 MT/s sets the throughput ceiling; sustained workloads will hit bandwidth limits before thermal throttling because the modules operate at 1.10V without a spreader.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?