NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.
Kingston Technology Corp.
64 GB DDR5-6400 ECC registered dual-rank module with CL52 latency and 1.10 V operation for server motherboards
This 64GB DDR5 kit contains eight 8GB modules running at 6400 MT/s with CL52 latency. Registered signal processing and on-die ECC protect data integrity in multi-socket servers and workstations. The 1.10V operating voltage matches the DDR5 baseline for dense configurations. Modules use Hynix 2Rx4 ICs on standard 288-pin DIMM PCBs.
Registered buffering and the low 1.10V rail keep per-module power modest even with eight ranks populated. Passive operation is typical in chassis with directed airflow; no heat spreaders are fitted. The tRAC of 32ns and 52-52-52 timings indicate standard JEDEC DDR5-6400 behaviour under sustained server loads.
Registered clock drivers reduce electrical load on the memory controller, allowing all eight DIMM slots to be filled without signal degradation. On-die ECC corrects single-bit errors inside each DRAM chip before data leaves the module. The combination targets uptime-critical workloads rather than low-latency desktop or overclocking use.
| Brand | Kingston |
|---|---|
| Model | KSM64R52BD4-64HA |
| Capacity | 64GB (8 x 8GB) |
| Type | 288-Pin DDR5 SDRAM |
| Speed | DDR5 6400 (PC5 51200) |
| CAS Latency | CL52 |
| Timing | 52-52-52 |
| tRAC | 32ns |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Hynix Chipset |
| Heat Spreader | No |
| Sūtījuma svars | 0.05 kg |
| Sūtījuma izmēri | 161 × 44 × 9 mm |
Align the notch on the module with the key in the server motherboard slot, press firmly until both retaining clips lock, then verify in BIOS that ECC and registered mode are enabled for the 2Rx4 configuration.
No scheduled maintenance is required; the modules have no heat spreader and run at 1.10V, so replacement is only necessary if a DIMM fails or the platform is upgraded beyond DDR5-6400.
The CL52 latency at 6400 MT/s sets the throughput ceiling; sustained workloads will hit bandwidth limits before thermal throttling because the modules operate at 1.10V without a spreader.
Arī šajā sadaļā
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Kriptovalūta, kurā maksājat, un valūta, kurā redzat cenas.
Nosūtīts no Jūsu maciņa, noformējot pasūtījumu
Tikai informatīvi — katalogā cenas norādītas ASV dolāros
Neviena valūta neatbilst.
Izvēlieties valodu, kurā vietne sarunājas ar Jums.
Pirmo reizi šeit?
Jau ir konts?
Automātiskas atiestatīšanas nav: šis veikals nesūta e-pastus, tāpēc nav arī vienreizējas saites, ko pieprasīt. Atstājiet adresi kontā, un tā tiks apstrādāta manuāli.
Pieprasījums saņemts
Uz Jūsu e-pastu nekas neatnāks — šis veikals vispār nesūta e-pastus. Kāds šos pieprasījumus apstrādā manuāli.
Atcerējāties?