Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Small spool of ivory filament, 3.0mm diameter, 0.25kg weight

Lay Filaments

Lay Filaments smartABS 3.0mm 0.25kg 3d printers accessory

SKU CH-VQYS-Y28NP

ABS filament for medium and large prints with low warp on cold beds and acetone smoothing, 2.85 mm diameter, 0.25 kg spool, prints at 235 °C

  • Less warping on a cold print bed
  • 90 percent fewer failures caused by warping
  • Acetone smoothing for glossy surface finish
  • Stronger layer bonds improve part strength
  • Prints at 235°C with 2.85 mm filament

SmartABS Filament for Large Prints

Lay Filaments smartABS is a 2.85 mm diameter ABS-type filament supplied on a 0.25 kg spool. It prints at 235 degC and is formulated for medium and large 3D prints where warping usually causes failures. The material delivers hard, tough parts with enhanced inter-layer adhesion for structural strength.

Cold-Bed Reliability and Post-Processing

Low warp on a cold bed removes the need for a heated build plate or an enclosure, simplifying day-to-day operation on open-frame printers. Finished parts can be smoothed with acetone vapour to eliminate layer lines and improve surface finish without additional hardware.

Geometry Limits of 0.25 kg Spools

The 0.25 kg net weight restricts the maximum single-print volume before a spool change is required. Very large models or batch production runs will need multiple spools staged in advance to avoid mid-print interruptions.

Põhijooned

  • Less warping on a cold print bed
  • 90 percent fewer failures caused by warping
  • Acetone smoothing for glossy surface finish
  • Stronger layer bonds improve part strength
  • Prints at 235°C with 2.85 mm filament

Tehnilised andmed

BrandLay Filaments

Küsimused selle toote kohta

What nozzle temperature is recommended for the 2.85 mm smartABS filament?

The supplier specifies a printing temperature of 235 °C for this material.

Will the 0.25 kg spool fit a standard 3.0 mm filament holder?

The filament diameter is 2.85 mm, which is the common size labelled as 3.0 mm and fits standard holders.

How do I get the best bed adhesion with smartABS on a cold bed?

Use a clean glass or PEI surface with a thin layer of glue stick or ABS slurry; the filament is formulated for low warp without a heated bed.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.