Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Small spool of ivory filament, 3.0mm diameter, 0.25kg weight

Lay Filaments

Lay Filaments smartABS 3.0mm 0.25kg 3d printers accessory

SKU CH-VQYS-Y28NP

ABS filament for medium and large prints with low warp on cold beds and acetone smoothing, 2.85 mm diameter, 0.25 kg spool, prints at 235 °C

  • Less warping on a cold print bed
  • 90 percent fewer failures caused by warping
  • Acetone smoothing for glossy surface finish
  • Stronger layer bonds improve part strength
  • Prints at 235°C with 2.85 mm filament

SmartABS Filament for Large Prints

Lay Filaments smartABS is a 2.85 mm diameter ABS-type filament supplied on a 0.25 kg spool. It prints at 235 degC and is formulated for medium and large 3D prints where warping usually causes failures. The material delivers hard, tough parts with enhanced inter-layer adhesion for structural strength.

Cold-Bed Reliability and Post-Processing

Low warp on a cold bed removes the need for a heated build plate or an enclosure, simplifying day-to-day operation on open-frame printers. Finished parts can be smoothed with acetone vapour to eliminate layer lines and improve surface finish without additional hardware.

Geometry Limits of 0.25 kg Spools

The 0.25 kg net weight restricts the maximum single-print volume before a spool change is required. Very large models or batch production runs will need multiple spools staged in advance to avoid mid-print interruptions.

Přednosti

  • Less warping on a cold print bed
  • 90 percent fewer failures caused by warping
  • Acetone smoothing for glossy surface finish
  • Stronger layer bonds improve part strength
  • Prints at 235°C with 2.85 mm filament

Specifikace

BrandLay Filaments

Otázky k tomuto produktu

What nozzle temperature is recommended for the 2.85 mm smartABS filament?

The supplier specifies a printing temperature of 235 °C for this material.

Will the 0.25 kg spool fit a standard 3.0 mm filament holder?

The filament diameter is 2.85 mm, which is the common size labelled as 3.0 mm and fits standard holders.

How do I get the best bed adhesion with smartABS on a cold bed?

Use a clean glass or PEI surface with a thin layer of glue stick or ABS slurry; the filament is formulated for low warp without a heated bed.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.