Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Small spool of ivory filament, 3.0mm diameter, 0.25kg weight

Lay Filaments

Lay Filaments smartABS 3.0mm 0.25kg 3d printers accessory

SKU CH-VQYS-Y28NP

ABS filament for medium and large prints with low warp on cold beds and acetone smoothing, 2.85 mm diameter, 0.25 kg spool, prints at 235 °C

  • Less warping on a cold print bed
  • 90 percent fewer failures caused by warping
  • Acetone smoothing for glossy surface finish
  • Stronger layer bonds improve part strength
  • Prints at 235°C with 2.85 mm filament

SmartABS Filament for Large Prints

Lay Filaments smartABS is a 2.85 mm diameter ABS-type filament supplied on a 0.25 kg spool. It prints at 235 degC and is formulated for medium and large 3D prints where warping usually causes failures. The material delivers hard, tough parts with enhanced inter-layer adhesion for structural strength.

Cold-Bed Reliability and Post-Processing

Low warp on a cold bed removes the need for a heated build plate or an enclosure, simplifying day-to-day operation on open-frame printers. Finished parts can be smoothed with acetone vapour to eliminate layer lines and improve surface finish without additional hardware.

Geometry Limits of 0.25 kg Spools

The 0.25 kg net weight restricts the maximum single-print volume before a spool change is required. Very large models or batch production runs will need multiple spools staged in advance to avoid mid-print interruptions.

Puncte forte

  • Less warping on a cold print bed
  • 90 percent fewer failures caused by warping
  • Acetone smoothing for glossy surface finish
  • Stronger layer bonds improve part strength
  • Prints at 235°C with 2.85 mm filament

Specificații

BrandLay Filaments

Întrebări despre acest articol

What nozzle temperature is recommended for the 2.85 mm smartABS filament?

The supplier specifies a printing temperature of 235 °C for this material.

Will the 0.25 kg spool fit a standard 3.0 mm filament holder?

The filament diameter is 2.85 mm, which is the common size labelled as 3.0 mm and fits standard holders.

How do I get the best bed adhesion with smartABS on a cold bed?

Use a clean glass or PEI surface with a thin layer of glue stick or ABS slurry; the filament is formulated for low warp without a heated bed.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.