Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
Ultra-thin IP67 waterproof power supply with anodized finish

myVolts

myVolts HRUW-150W-24V power supply

SKU CH-YQD7-1Q339 MPN HRUW-150W-24V

A 150 W switching supply converts 100–240 VAC at 50/60 Hz to 24 VDC at 6.25 A in an IP67-rated ultra-thin case

  • TypeAT
  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

150W 24V switching supply for LED projects

This AC-DC unit delivers 150 watts at 24 volts DC with a 6.25 amp output. It accepts a wide 100-240 VAC input at 50 or 60 Hz for global mains compatibility. The IP67 rating means it is sealed against dust and temporary immersion. Designed for installers who need a rugged, low-profile power source for lighting strips and similar DC loads.

Ultra-thin IP67 housing with anodised finish

The waterproof case is built to strict quality-control standards and features a wear-resistant anodised surface. Marked parameters on the body aid quick identification during installation. Its ultra-thin profile allows mounting in tight channels or behind panels where thicker supplies will not fit. Simple wiring and no extra configuration steps reduce on-site labour.

Replaces bulky non-waterproof transformers

Swap out open-frame or ventilated units that cannot survive damp or outdoor environments. The jump is worth it when the installation demands full dust and water ingress protection in a slim form factor. Not suited for builds requiring adjustable voltage, remote sensing or parallel redundancy features.

Põhijooned

  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

Tehnilised andmed

TypeAT

Küsimused selle toote kohta

What input voltage range does the HRUW-150W-24V accept and at which frequencies?

The unit accepts 100-240VAC at 50/60Hz, making it suitable for mains supplies worldwide without a separate voltage selector.

What physical mounting provisions does the IP67 ultra-thin supply include?

The anodised aluminium case has integral mounting flanges with through-holes, allowing direct screw fixing to a flat surface without a separate bracket.

How is the HRUW-150W-24V wired in, and what is the common mistake?

Connect live, neutral and earth to the marked input terminals and the load to the 24VDC output terminals; the frequent error is reversing the DC polarity, which will not damage the supply but leaves the LED strip unlit.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.