Akceptujemy kryptowaluty — posiadane środki można więc wykorzystać na zakup prawdziwego sprzętu.Płatność kryptowalutą — realny sprzęt w zamian. Bezpłatna, ubezpieczona dostawa na całym świecie powyżej 399 $. Neutralne kartony, bez oznaczeń, wysyłane z Niemiec.Bezpłatna, ubezpieczona dostawa powyżej 399 $. Kurs zostaje zablokowany na 30 minut od otwarcia kasy.Kurs zablokowany na 30 minut. Każdy produkt jest fabrycznie zapieczętowany, jego numer seryjny jest sprawdzany, a całość objęta jest 24-miesięczną gwarancją.Zapieczętowane fabrycznie, 24 miesiące gwarancji.

Obserwowane produkty Zaloguj się
Ultra-thin IP67 waterproof power supply with anodized finish

myVolts

myVolts HRUW-150W-24V power supply

SKU CH-YQD7-1Q339 MPN HRUW-150W-24V

A 150 W switching supply converts 100–240 VAC at 50/60 Hz to 24 VDC at 6.25 A in an IP67-rated ultra-thin case

  • TypeAT
  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

150W 24V switching supply for LED projects

This AC-DC unit delivers 150 watts at 24 volts DC with a 6.25 amp output. It accepts a wide 100-240 VAC input at 50 or 60 Hz for global mains compatibility. The IP67 rating means it is sealed against dust and temporary immersion. Designed for installers who need a rugged, low-profile power source for lighting strips and similar DC loads.

Ultra-thin IP67 housing with anodised finish

The waterproof case is built to strict quality-control standards and features a wear-resistant anodised surface. Marked parameters on the body aid quick identification during installation. Its ultra-thin profile allows mounting in tight channels or behind panels where thicker supplies will not fit. Simple wiring and no extra configuration steps reduce on-site labour.

Replaces bulky non-waterproof transformers

Swap out open-frame or ventilated units that cannot survive damp or outdoor environments. The jump is worth it when the installation demands full dust and water ingress protection in a slim form factor. Not suited for builds requiring adjustable voltage, remote sensing or parallel redundancy features.

Najważniejsze cechy

  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

Specyfikacja

TypeAT

Pytania dotyczące tego produktu

What input voltage range does the HRUW-150W-24V accept and at which frequencies?

The unit accepts 100-240VAC at 50/60Hz, making it suitable for mains supplies worldwide without a separate voltage selector.

What physical mounting provisions does the IP67 ultra-thin supply include?

The anodised aluminium case has integral mounting flanges with through-holes, allowing direct screw fixing to a flat surface without a separate bracket.

How is the HRUW-150W-24V wired in, and what is the common mistake?

Connect live, neutral and earth to the marked input terminals and the load to the 24VDC output terminals; the frequent error is reversing the DC polarity, which will not damage the supply but leaves the LED strip unlit.

Także w tym dziale

Klienci porównywali też te produkty

Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.