Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Ultra-thin IP67 waterproof power supply with anodized finish

myVolts

myVolts HRUW-150W-24V power supply

SKU CH-YQD7-1Q339 MPN HRUW-150W-24V

A 150 W switching supply converts 100–240 VAC at 50/60 Hz to 24 VDC at 6.25 A in an IP67-rated ultra-thin case

  • TypeAT
  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

150W 24V switching supply for LED projects

This AC-DC unit delivers 150 watts at 24 volts DC with a 6.25 amp output. It accepts a wide 100-240 VAC input at 50 or 60 Hz for global mains compatibility. The IP67 rating means it is sealed against dust and temporary immersion. Designed for installers who need a rugged, low-profile power source for lighting strips and similar DC loads.

Ultra-thin IP67 housing with anodised finish

The waterproof case is built to strict quality-control standards and features a wear-resistant anodised surface. Marked parameters on the body aid quick identification during installation. Its ultra-thin profile allows mounting in tight channels or behind panels where thicker supplies will not fit. Simple wiring and no extra configuration steps reduce on-site labour.

Replaces bulky non-waterproof transformers

Swap out open-frame or ventilated units that cannot survive damp or outdoor environments. The jump is worth it when the installation demands full dust and water ingress protection in a slim form factor. Not suited for builds requiring adjustable voltage, remote sensing or parallel redundancy features.

Helstu kostir

  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

Tæknilýsing

TypeAT

Spurningar um þessa vöru

What input voltage range does the HRUW-150W-24V accept and at which frequencies?

The unit accepts 100-240VAC at 50/60Hz, making it suitable for mains supplies worldwide without a separate voltage selector.

What physical mounting provisions does the IP67 ultra-thin supply include?

The anodised aluminium case has integral mounting flanges with through-holes, allowing direct screw fixing to a flat surface without a separate bracket.

How is the HRUW-150W-24V wired in, and what is the common mistake?

Connect live, neutral and earth to the marked input terminals and the load to the 24VDC output terminals; the frequent error is reversing the DC polarity, which will not damage the supply but leaves the LED strip unlit.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.