نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.

قائمة الرصد تسجيل الدخول
Ultra-thin IP67 waterproof power supply with anodized finish

myVolts

myVolts HRUW-150W-24V power supply

SKU CH-YQD7-1Q339 MPN HRUW-150W-24V

A 150 W switching supply converts 100–240 VAC at 50/60 Hz to 24 VDC at 6.25 A in an IP67-rated ultra-thin case

  • TypeAT
  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

150W 24V switching supply for LED projects

This AC-DC unit delivers 150 watts at 24 volts DC with a 6.25 amp output. It accepts a wide 100-240 VAC input at 50 or 60 Hz for global mains compatibility. The IP67 rating means it is sealed against dust and temporary immersion. Designed for installers who need a rugged, low-profile power source for lighting strips and similar DC loads.

Ultra-thin IP67 housing with anodised finish

The waterproof case is built to strict quality-control standards and features a wear-resistant anodised surface. Marked parameters on the body aid quick identification during installation. Its ultra-thin profile allows mounting in tight channels or behind panels where thicker supplies will not fit. Simple wiring and no extra configuration steps reduce on-site labour.

Replaces bulky non-waterproof transformers

Swap out open-frame or ventilated units that cannot survive damp or outdoor environments. The jump is worth it when the installation demands full dust and water ingress protection in a slim form factor. Not suited for builds requiring adjustable voltage, remote sensing or parallel redundancy features.

أبرز المميزات

  • Simple operation with no extra steps required
  • IP67 waterproof rating for wet or outdoor use
  • Ultra-thin design with marked parameters for easy setup
  • Anodized wear-resistant surface for long-term durability
  • 150 W output at 24 V DC with 6.25 A current

المواصفات

TypeAT

أسئلة حول هذا المنتج

What input voltage range does the HRUW-150W-24V accept and at which frequencies?

The unit accepts 100-240VAC at 50/60Hz, making it suitable for mains supplies worldwide without a separate voltage selector.

What physical mounting provisions does the IP67 ultra-thin supply include?

The anodised aluminium case has integral mounting flanges with through-holes, allowing direct screw fixing to a flat surface without a separate bracket.

How is the HRUW-150W-24V wired in, and what is the common mistake?

Connect live, neutral and earth to the marked input terminals and the load to the 24VDC output terminals; the frequent error is reversing the DC polarity, which will not damage the supply but leaves the LED strip unlit.

أيضًا في هذا القسم

عملاء قارنوا هذه المنتجات

نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.