Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse

NEMIX RAM

NEMIX RAM 64GB DDR5 4800 CL40 2Rx4 1.1V ECC RDIMM ASRock SIENAD10HM3 memory upgrade

SKU CH-T1Q1-3068D

64GB DDR5 4800 RDIMM with ECC and registered buffering for ASRock Rack SIENAD10HM3 servers

  • Capacity64GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • 64 GB capacity doubles memory headroom for heavy virtualization workloads
  • DDR5 4800 speed delivers 38 400 MT/s bandwidth for faster data throughput
  • CL40 latency at 1.1 V balances responsive timing with low power draw
  • 2Rx4 registered ECC architecture corrects single-bit errors and stabilises fully populated slots
  • 288-pin RDIMM form factor matches ASRock Rack SIENAD10HM3 motherboard requirements

64GB DDR5-4800 ECC RDIMM upgrade

This 64GB DDR5 module runs at 4800MHz with CL40 latency and 1.10V operation. It uses a 288-pin registered DIMM form factor with 2Rx4 organisation and on-die ECC. The memory is validated for the ASRock Rack SIENAD10HM3 motherboard.

Suited for single-slot capacity expansion

Administrators adding memory to an ASRock Rack SIENAD10HM3 system receive the exact rank, voltage and timing the board expects. Builders using consumer UDIMM or SODIMM slots, or boards that require unbuffered memory, cannot use this registered module.

Handles full-capacity population in registered

The registered architecture lets every supported slot run at 64GB without loading the memory controller. Systems limited to lower-density DIMMs or unbuffered topologies will not accept this module.

Põhijooned

  • 64 GB capacity doubles memory headroom for heavy virtualization workloads
  • DDR5 4800 speed delivers 38 400 MT/s bandwidth for faster data throughput
  • CL40 latency at 1.1 V balances responsive timing with low power draw
  • 2Rx4 registered ECC architecture corrects single-bit errors and stabilises fully populated slots
  • 288-pin RDIMM form factor matches ASRock Rack SIENAD10HM3 motherboard requirements

Tehnilised andmed

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-924K1
Capacity64GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemASRock Rack
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Selle mudeli teised versioonid

5 veel samast sarjast

Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.

Küsimused selle toote kohta

Does the ASRock Rack SIENAD10HM3 motherboard need DDR5 RDIMM slots to accept this 64 GB module?

Yes. The module is a 288-pin DDR5 RDIMM; the board must provide DDR5 RDIMM slots for it to seat and operate.

Can I keep my existing DDR5 4800 RDIMMs and add this 2Rx4 CL40 kit alongside them?

Mixing is possible only if the other DIMMs are also DDR5 4800 registered ECC with matching voltage and timing; otherwise the system will down-clock or fail to boot.

How do I confirm the kit is running at DDR5 4800 with ECC active after installation?

Enter the BIOS or use a hardware-information utility and verify the memory speed reads 4800 MT/s, CAS latency shows CL40 and ECC status reports enabled.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.