Seagate
Seagate ST9600205SS Savvio 10K.5 600GB 10000RPM 2.5" SAS internal hard drive
A 2.5" SAS enterprise drive delivering 600 GB at 10 000 RPM with 64 MB cache
- 600 GB capacity stores large datasets
- 10 000 RPM spindle delivers fast data access
- 64 MB cache buffers frequent read and write operations
- SAS 6 Gb/s interface connects to enterprise controllers
- 5 inch form factor fits dense server bays
Enterprise 2.5-inch SAS drive
The Seagate Savvio 10K.5 is a 600 GB internal hard drive spinning at 10000 RPM with a 6 Gb/s SAS interface and 64 MB cache. It targets servers and storage arrays that need fast, consistent access to transactional data. The 2.5-inch form factor fits dense drive bays in rackmount chassis and blade systems.
Small form factor with SAS connectivity
A standard 2.5-inch SAS connector provides both power and data through a single backplane slot, simplifying hot-swap maintenance in compatible enclosures. The drive carries zero hours on the clock, so it arrives without prior wear. Mechanical mounting points follow the common 2.5-inch pattern used in enterprise trays.
High-speed spindle with managed thermals
The 10000 RPM spindle delivers low latency for random workloads while the SAS interface supports command queuing to optimise throughput. Power draw and acoustic output remain within typical enterprise 2.5-inch ranges, allowing multiple units to operate side by side in cooled cabinets without exceeding thermal limits.
Põhijooned
- 600 GB capacity stores large datasets
- 10 000 RPM spindle delivers fast data access
- 64 MB cache buffers frequent read and write operations
- SAS 6 Gb/s interface connects to enterprise controllers
- 5 inch form factor fits dense server bays
Tehnilised andmed
Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.
Küsimused selle toote kohta
What does the SAS 6Gb/s interface limit in real-world throughput?
The SAS 6Gb/s link caps sustained transfers at roughly 600MB/s, so the 10000RPM drive cannot exceed that ceiling even on sequential workloads.
Which drive bay and mounting holes does the 2.5" form factor require?
It fits a standard 2.5-inch bay with the industry screw pattern; no adapter is needed for servers or arrays that accept 2.5-inch SAS drives.
How is the drive installed in a hot-swap tray, and what step is often missed?
Slide the unit into the tray until the SAS connector seats firmly, then secure the tray latch; the step often missed is verifying the latch clicks fully to guarantee electrical contact.
Veel samast osakonnast
Kliendid võrdlesid neid ka
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
