Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.

Hinnavaatlus Logi sisse
SFF-8482 SAS to SATA adapter cable with 15-pin power connector

SMUGDESK

SMUGDESK SFF-8482 SAS to SATA Adapter Cable with 15Pin Power

SKU CH-WYFS-SPH5S

Connects SFF-8482 SAS drives to SATA motherboards with a 15-pin power port for 2.5-inch and 3.5-inch drives

  • Connect SAS drives to SATA motherboards using SFF-8482 interface
  • Independent 15Pin SATA power port delivers stable drive operation
  • Supports 2.5 and 3.5 inch SFF-8482 SAS hard drives
  • Shielded precision connectors reduce interference for reliable data transfer
  • Plug-and-play design works without drivers for quick setup

SAS-to-SATA conversion cable

This SMUGDESK adapter cable bridges SFF-8482 SAS hard drives to standard SATA motherboard ports. It targets technicians and hobbyists who need to read server disks on desktop or workstation boards without buying a dedicated SAS controller. The independent 15Pin SATA power connector supplies the drive directly from a PSU cable.

Unidirectional SFF-8482 limitation

The cable works only from an SFF-8482 SAS drive to a SATA host; it cannot make a SATA drive operate on a SAS controller. Signal integrity relies on the SATA host controller speaking the SAS-to-SATA protocol subset, so compatibility depends on the motherboard implementation rather than the adapter itself.

Dual form-factor support with power headroom

Both 2.5-inch and 3.5-inch SFF-8482 SAS HDDs are supported, drawing power from the separate 15Pin port to avoid detection failures. The design handles typical sustained reads for data recovery or storage testing, but it cannot overcome bandwidth ceilings or command-set differences inherent to the SATA interface.

Põhijooned

  • Connect SAS drives to SATA motherboards using SFF-8482 interface
  • Independent 15Pin SATA power port delivers stable drive operation
  • Supports 2.5 and 3.5 inch SFF-8482 SAS hard drives
  • Shielded precision connectors reduce interference for reliable data transfer
  • Plug-and-play design works without drivers for quick setup

Tehnilised andmed

Selle toote kohta ei ole veel tehnilisi andmeid avaldatud.

Küsimused selle toote kohta

Should I get the 2.5-inch or 3.5-inch version of this SFF-8482 adapter?

One cable works with both 2.5 and 3.5 inch SFF-8482 SAS drives, so no separate version is needed.

Will this SFF-8482 adapter let my SAS drive run at full SATA speed on a desktop motherboard?

The cable passes SATA signals from the SAS drive to the motherboard port; actual throughput is limited by the drive and the SATA controller.

Does the 15Pin power port on this SFF-8482 adapter draw from the motherboard or the PSU?

The 15Pin port takes a standard SATA power cable from the PSU to supply the SAS drive directly.

Veel samast osakonnast

Kliendid võrdlesid neid ka

Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.