Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
SFF-8482 SAS to SATA adapter cable with 15-pin power connector

SMUGDESK

SMUGDESK SFF-8482 SAS to SATA Adapter Cable with 15Pin Power

SKU CH-WYFS-SPH5S

Connects SFF-8482 SAS drives to SATA motherboards with a 15-pin power port for 2.5-inch and 3.5-inch drives

  • Connect SAS drives to SATA motherboards using SFF-8482 interface
  • Independent 15Pin SATA power port delivers stable drive operation
  • Supports 2.5 and 3.5 inch SFF-8482 SAS hard drives
  • Shielded precision connectors reduce interference for reliable data transfer
  • Plug-and-play design works without drivers for quick setup

SAS-to-SATA conversion cable

This SMUGDESK adapter cable bridges SFF-8482 SAS hard drives to standard SATA motherboard ports. It targets technicians and hobbyists who need to read server disks on desktop or workstation boards without buying a dedicated SAS controller. The independent 15Pin SATA power connector supplies the drive directly from a PSU cable.

Unidirectional SFF-8482 limitation

The cable works only from an SFF-8482 SAS drive to a SATA host; it cannot make a SATA drive operate on a SAS controller. Signal integrity relies on the SATA host controller speaking the SAS-to-SATA protocol subset, so compatibility depends on the motherboard implementation rather than the adapter itself.

Dual form-factor support with power headroom

Both 2.5-inch and 3.5-inch SFF-8482 SAS HDDs are supported, drawing power from the separate 15Pin port to avoid detection failures. The design handles typical sustained reads for data recovery or storage testing, but it cannot overcome bandwidth ceilings or command-set differences inherent to the SATA interface.

Prednosti

  • Connect SAS drives to SATA motherboards using SFF-8482 interface
  • Independent 15Pin SATA power port delivers stable drive operation
  • Supports 2.5 and 3.5 inch SFF-8482 SAS hard drives
  • Shielded precision connectors reduce interference for reliable data transfer
  • Plug-and-play design works without drivers for quick setup

Špecifikácie

Pre tento produkt zatiaľ nie sú zverejnené žiadne špecifikácie.

Otázky k tomuto produktu

Should I get the 2.5-inch or 3.5-inch version of this SFF-8482 adapter?

One cable works with both 2.5 and 3.5 inch SFF-8482 SAS drives, so no separate version is needed.

Will this SFF-8482 adapter let my SAS drive run at full SATA speed on a desktop motherboard?

The cable passes SATA signals from the SAS drive to the motherboard port; actual throughput is limited by the drive and the SATA controller.

Does the 15Pin power port on this SFF-8482 adapter draw from the motherboard or the PSU?

The 15Pin port takes a standard SATA power cable from the PSU to supply the SAS drive directly.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.