NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
KHACHIMO
An ATX power supply delivering 250 watts with 80 PLUS Gold efficiency, zero-RPM fan mode and resonant LLC topology for quiet, efficient operation
This KHACHIMO unit is a 250 watt ATX power supply designed for compatible Cisco WS-C2960XR-24TS network switches. It delivers the rated output required by the original equipment and carries an 80 PLUS Gold certification for high efficiency. The part number PWR-C2-250WAC matches the OEM replacement specification for these managed switches.
The resonant LLC topology with DC-to-DC conversion maintains clean, consistent power delivery during continuous operation. 80 PLUS Gold efficiency reduces waste heat and keeps internal temperatures lower under prolonged load. The zero RPM fan mode remains inactive at higher sustained outputs, so the fan runs to manage thermal performance when the switch is fully utilised.
The supply slides into the switch chassis and locks with the built-in latch mechanism. Correct alignment of the connector is essential; forcing the unit can damage the backplane pins. No additional cables or adapters are required beyond the standard AC input cord. Installers should verify the switch firmware supports hot-swap replacement before removing the old unit under power.
| Type | ATX |
|---|
The Zero RPM fan mode stops the fan completely at low and medium loads, giving near-silent operation, while 80 PLUS Gold efficiency keeps heat and coil whine low during extended use.
It follows the ATX form factor, so a standard ATX motherboard power connector and the usual peripheral leads are all that are required for installation.
Yes, the ATX design and DC-to-DC conversion deliver clean, consistent power that is compatible with legacy hardware you may retain.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?