Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Silver ATX power supply unit with rear fan grille and power socket

KHACHIMO

KHACHIMO WS-C2960XR-24TS 250W Power Supply PWR-C2-250WAC

SKU CH-85Q4-HBB2V

An ATX power supply delivering 250 watts with 80 PLUS Gold efficiency, zero-RPM fan mode and resonant LLC topology for quiet, efficient operation

  • TypeATX
  • Faster wake-from-sleep with Modern Standby support
  • Lower power draw and heat via 80 PLUS Gold efficiency
  • Near-silent operation from Zero RPM fan mode at low loads
  • Clean, stable power delivery using resonant LLC with DC-to-DC conversion
  • Brand-new 250 W ATX unit built for WS-C2960XR-24TS compatibility

KHACHIMO 250W ATX Power Supply

This KHACHIMO unit is a 250 watt ATX power supply designed for compatible Cisco WS-C2960XR-24TS network switches. It delivers the rated output required by the original equipment and carries an 80 PLUS Gold certification for high efficiency. The part number PWR-C2-250WAC matches the OEM replacement specification for these managed switches.

Sustained Load Behaviour

The resonant LLC topology with DC-to-DC conversion maintains clean, consistent power delivery during continuous operation. 80 PLUS Gold efficiency reduces waste heat and keeps internal temperatures lower under prolonged load. The zero RPM fan mode remains inactive at higher sustained outputs, so the fan runs to manage thermal performance when the switch is fully utilised.

Installation Notes

The supply slides into the switch chassis and locks with the built-in latch mechanism. Correct alignment of the connector is essential; forcing the unit can damage the backplane pins. No additional cables or adapters are required beyond the standard AC input cord. Installers should verify the switch firmware supports hot-swap replacement before removing the old unit under power.

Kohokohdat

  • Faster wake-from-sleep with Modern Standby support
  • Lower power draw and heat via 80 PLUS Gold efficiency
  • Near-silent operation from Zero RPM fan mode at low loads
  • Clean, stable power delivery using resonant LLC with DC-to-DC conversion
  • Brand-new 250 W ATX unit built for WS-C2960XR-24TS compatibility

Tekniset tiedot

TypeATX

Kysymyksiä tästä tuotteesta

How loud is the 250W unit when it runs all day?

The Zero RPM fan mode stops the fan completely at low and medium loads, giving near-silent operation, while 80 PLUS Gold efficiency keeps heat and coil whine low during extended use.

Which cables or connectors must I already have to install this supply?

It follows the ATX form factor, so a standard ATX motherboard power connector and the usual peripheral leads are all that are required for installation.

Will this 250W model work with older components I plan to keep?

Yes, the ATX design and DC-to-DC conversion deliver clean, consistent power that is compatible with legacy hardware you may retain.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.