NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
myVolts
A 30 cm PSU cable extension kit with 24-pin motherboard, two CPU and three GPU connectors in red sleeved 18AWG wiring
This 30 cm extension kit adds a 24-pin motherboard cable, two 4+4-pin CPU cables and three 6+2-pin GPU cables to an existing power supply. The 18AWG UL 1015 tinned copper conductors and high-density braided sleeves give a professional look while staying routable inside the case. Cable combs are included for clean alignment. Builders who want a single-colour accent without replacing the PSU itself will find the kit convenient.
The set suits anyone extending a standard ATX power supply in a custom loop or air-cooled build where the stock cables fall short of the motherboard and graphics card. It does not help builders who need longer runs than 30 cm, who require a different colour than red, or who want pre-curved cables ready to install without training. Systems using non-standard PSU pin-outs or proprietary connectors are also outside the kit's scope.
The 300 mm length is the single figure that decides fit; measure from your PSU to the 24-pin, CPU and GPU headers before ordering. If the distance exceeds 30 cm the extensions will not reach, and no other length is included in this package.
| Type | AT |
|---|
Connect each 30 cm extension between the PSU and the component, then use the supplied cable combs to align the 18 AWG wires; the step many miss is training the braid into smooth curves before final tightening.
Inspect the braided sleeves and combs annually for abrasion or loose clips; replace any cable that shows conductor exposure or melted insulation, otherwise the kit is rated for continuous use.
The 18 AWG conductors set the practical ceiling; sustained draws near their ampacity will raise sleeve temperature first, so keep total load within the wire gauge rating.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?