Akceptujemy kryptowaluty — posiadane środki można więc wykorzystać na zakup prawdziwego sprzętu.Płatność kryptowalutą — realny sprzęt w zamian. Bezpłatna, ubezpieczona dostawa na całym świecie powyżej 399 $. Neutralne kartony, bez oznaczeń, wysyłane z Niemiec.Bezpłatna, ubezpieczona dostawa powyżej 399 $. Kurs zostaje zablokowany na 30 minut od otwarcia kasy.Kurs zablokowany na 30 minut. Każdy produkt jest fabrycznie zapieczętowany, jego numer seryjny jest sprawdzany, a całość objęta jest 24-miesięczną gwarancją.Zapieczętowane fabrycznie, 24 miesiące gwarancji.

Obserwowane produkty Zaloguj się
Red braided PSU cable extension kit with 24-pin, two CPU and three GPU connectors

myVolts

myVolts 30cm PSU Cable Extension Kit 24-Pin 2x CPU 3x GPU Red

SKU CH-HPTV-4JQMW

A 30 cm PSU cable extension kit with 24-pin motherboard, two CPU and three GPU connectors in red sleeved 18AWG wiring

  • TypeAT
  • Vivid red sleeving sharpens build aesthetics with 17 colour options
  • 18AWG UL 1015 tinned copper wires deliver reliable power routing
  • 300 mm length suits compact cases and clean cable management
  • Kit includes 24-pin, 2× CPU 4+4-pin and 3× GPU 6+2-pin connectors
  • High-density braided sleeves balance stiffness and flexibility for tidy routing

Kit contents and purpose

This 30 cm extension kit adds a 24-pin motherboard cable, two 4+4-pin CPU cables and three 6+2-pin GPU cables to an existing power supply. The 18AWG UL 1015 tinned copper conductors and high-density braided sleeves give a professional look while staying routable inside the case. Cable combs are included for clean alignment. Builders who want a single-colour accent without replacing the PSU itself will find the kit convenient.

Who should buy and who should not

The set suits anyone extending a standard ATX power supply in a custom loop or air-cooled build where the stock cables fall short of the motherboard and graphics card. It does not help builders who need longer runs than 30 cm, who require a different colour than red, or who want pre-curved cables ready to install without training. Systems using non-standard PSU pin-outs or proprietary connectors are also outside the kit's scope.

Critical specification check

The 300 mm length is the single figure that decides fit; measure from your PSU to the 24-pin, CPU and GPU headers before ordering. If the distance exceeds 30 cm the extensions will not reach, and no other length is included in this package.

Najważniejsze cechy

  • Vivid red sleeving sharpens build aesthetics with 17 colour options
  • 18AWG UL 1015 tinned copper wires deliver reliable power routing
  • 300 mm length suits compact cases and clean cable management
  • Kit includes 24-pin, 2× CPU 4+4-pin and 3× GPU 6+2-pin connectors
  • High-density braided sleeves balance stiffness and flexibility for tidy routing

Specyfikacja

TypeAT

Pytania dotyczące tego produktu

How do I install the 24-pin, dual CPU and triple GPU extension cables, and what step is often missed?

Connect each 30 cm extension between the PSU and the component, then use the supplied cable combs to align the 18 AWG wires; the step many miss is training the braid into smooth curves before final tightening.

What maintenance or replacement will the 18 AWG UL 1015 tinned-copper extensions need over time?

Inspect the braided sleeves and combs annually for abrasion or loose clips; replace any cable that shows conductor exposure or melted insulation, otherwise the kit is rated for continuous use.

What thermal or current limit appears first when the 24-pin, CPU and GPU extensions run at full load for long periods?

The 18 AWG conductors set the practical ceiling; sustained draws near their ampacity will raise sleeve temperature first, so keep total load within the wire gauge rating.

Także w tym dziale

Klienci porównywali też te produkty

Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.