Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Two green DDR5 RDIMM modules, black chips, no heat spreaders, 288-pin edge connectors

NEMIX RAM

NEMIX RAM 256GB (2x128GB) DDR5 5600 CL46 ECC Registered RDIMM Supermicro H13SSH memory upgrade

SKU CH-T5AM-SKPDF

256 GB DDR5 5600 ECC registered RDIMM kit (2×128 GB, CL46, 1.1 V) validated for Supermicro H13SSH servers

  • Capacity256GB (2 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 256 GB total capacity with two 128 GB modules for maximum density
  • DDR5-5600 speed rated at PC5-44800 for high-throughput server workloads
  • CL46 latency and 1.1 V operation matching the controller's exact timing requirements
  • Registered ECC RDIMM design corrects single-bit errors and buffers signals for full-slot stability
  • Verified compatibility with the Supermicro H13SSH motherboard and its 288-pin RDIMM slots

Exact DDR5-5600 ECC RDIMM kit for Supermicro H13SSH

This 256 GB kit contains two 128 GB modules built to the DDR5 5600 standard with CL46 timing and 1.1 V operation. Registered ECC architecture and 2Rx4 organisation match the memory controller expectations of the Supermicro H13SSH motherboard so the full capacity is recognised at rated speed.

288-pin Registered form factor with major-OEM DRAM

The RDIMM modules use Samsung, Micron or Hynix chips without heat spreaders, keeping the profile low for dense server chassis. Registered buffering reduces electrical load on the controller when all slots are populated, while on-die ECC corrects single-bit errors before they affect workloads.

DDR5 platform limits require manual population

DDR5 RDIMM topology on this platform enforces strict slot-order rules and maximum capacity per channel that differ by BIOS revision. The kit delivers the specified 5600 MT/s rate only when installed according to the motherboard manual; otherwise the system may down-clock or fail to post. Buyers who need higher frequencies, lower latencies or non-ECC operation should look elsewhere.

Istaknuto

  • 256 GB total capacity with two 128 GB modules for maximum density
  • DDR5-5600 speed rated at PC5-44800 for high-throughput server workloads
  • CL46 latency and 1.1 V operation matching the controller's exact timing requirements
  • Registered ECC RDIMM design corrects single-bit errors and buffers signals for full-slot stability
  • Verified compatibility with the Supermicro H13SSH motherboard and its 288-pin RDIMM slots

Specifikacije

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-724K2
Capacity256GB (2 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 2X128GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Pitanja o ovom artiklu

Does this kit run at the full DDR5 5600 speed on the Supermicro H13SSH?

Yes, the modules are DDR5 5600 (PC5-44800) with CL46 timing and 1.10 V, matching the memory controller specification so the board recognises the full 256 GB at rated speed.

What physical slot and form factor does the 288-pin RDIMM require on the H13SSH?

The kit uses 288-pin registered RDIMMs; the H13SSH provides standard DDR5 RDIMM slots with the matching key notch, so each 128 GB module seats directly without adapters.

Which population order should I follow when installing both 128 GB RDIMMs?

Install the first module in the slot designated as DIMM 1A (or CPU1 Channel A Slot 1) in the H13SSH manual, then the second in the matching slot on the next channel; this sequence lets the memory controller initialise the full 256 GB correctly.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.