Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Green bare circuit board with gold edge connectors and black memory chips

NEMIX RAM

NEMIX RAM 8GB DDR4 2133MHz CL15 288-Pin VLP ECC RDIMM 1Rx4 memory upgrade

SKU CH-4D39-4G78Q

An 8 GB DDR4-2133 registered ECC RDIMM with CL15 latency and 1.2 V operation for compatible Hynix servers

  • Capacity8GB
  • SpeedDDR4 2133 (PC4 17000)
  • ECCYes
  • Buffered/RegisteredRegistered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • ECC protection prevents data corruption in servers
  • Registered signal buffering improves system stability
  • 2V operation reduces power consumption
  • VLP design fits compact server chassis
  • CL15 latency delivers responsive performance

8GB DDR4 ECC RDIMM for Hynix Servers

This registered DDR4 module delivers 8 GB of ECC-protected memory at 2133 MT/s with CL15 latency. It operates at 1.2 V and uses a 1Rx4 organisation on a 288-pin VLP form factor. The stick is built for Hynix server and workstation platforms that require registered error-correcting memory.

Replaces non-ECC or slower registered DIMMs

Upgrading from standard unbuffered memory adds hardware error correction for data integrity in mission-critical workloads. Moving from a lower-speed registered module to this PC4-17000 part increases bandwidth while keeping the same registered signal loading. The jump is worth it when your platform demands registered ECC and you need the 2133 MT/s speed grade.

Verify registered ECC support and slot type

Confirm your motherboard accepts 288-pin DDR4 registered DIMMs and enables ECC in the BIOS. The module is not compatible with systems that only support unbuffered UDIMMs or 204-pin SODIMM slots. Check the qualified vendor list for the exact part number MR17000-814K1 before ordering.

Istaknuto

  • ECC protection prevents data corruption in servers
  • Registered signal buffering improves system stability
  • 2V operation reduces power consumption
  • VLP design fits compact server chassis
  • CL15 latency delivers responsive performance

Specifikacije

BrandNEMIX RAM
SeriesHynix Server/Workstaion Compatible Series Memory
ModelHynix DDR4 2133MHZ ECC RDIMM Registered Server Memory
Part NumberMR17000-814K1
Capacity8GB
SpeedDDR4 2133 (PC4 17000)
ECCYes
Buffered/RegisteredRegistered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemHynix
CAS LatencyCL15
Heat SpreaderNo
Type204-Pin DDR3 SODIMM
Rank1Rx4
FeaturesDDR4 ECC Registered RDIMM Server Motherboard Compatible
Package Content8GB (1X8GB) DDR4 2133MHZ PC4-17000 1Rx4 1.2V CL15 288-PIN ECC RDIMM Registered Server Memory

Pitanja o ovom artiklu

Will this 288-pin VLP RDIMM fit in a standard-height server slot?

The very-low-profile design fits standard 288-pin DDR4 RDIMM sockets; verify chassis clearance for the shorter module height.

What is the correct way to seat this registered ECC module so the system recognises the full 8 GB?

Align the notch, press firmly until both retaining clips click, then confirm 2133 MT/s and ECC active in BIOS.

When should this 1.2 V DDR4 RDIMM be replaced?

Replace the module if the server logs uncorrectable ECC errors or recurring corrected errors that persist after reseating.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.