BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
RIMLANCE
An 8 GB dual-channel DDR3 kit running at 1333 MHz with CL9 latency and 1.5 V operation
This 8GB kit contains two 4GB unbuffered DIMMs built for DDR3 desktop platforms. It targets users who need a straightforward capacity increase for everyday multitasking and office workloads. The modules use major-brand chips selected for broad compatibility with standard motherboards. Installation requires only slotting the sticks into available memory sockets.
The kit runs at the standard 1.5V DDR3 voltage with a 1333MHz clock and PC3-10600 rating. At this voltage and speed the modules draw modest power and produce minimal heat under normal loads. CL9 latency keeps response times tight for typical desktop tasks. No active cooling is required for stock operation.
The unbuffered 2RX8 design works without manual BIOS tuning on most supporting boards. There is no bundled software, lighting control or heat-spreader accessory included. The package delivers the two DIMMs only, letting the system auto-detect timings at boot. This keeps the upgrade process simple for non-technical users.
| Brand | RIMLANCE |
|---|---|
| Model | RUD10600D8C2K8 |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
The kit uses the standard 240-pin DDR3 UDIMM form factor; check that your motherboard has DDR3 slots and supports 1333 MHz unbuffered non-ECC memory.
CL9 at 1333 MHz is the standard JEDEC timing for PC3-10600 and provides responsive performance for everyday desktop workloads.
Yes, 1.5 V is the standard operating voltage for DDR3 UDIMMs, so no special voltage settings are needed on compatible boards.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?