BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
אנחנו מקבלים תשלום בקריפטו — כך שמטבעות הקריפטו שברשותך יכולים לקנות ציוד אמיתי.שלם בקריפטו, קנה איתו ציוד אמיתי. משלוח חינם ומבוטח לכל העולם מעל 399 $. קרטונים ניטרליים וללא מיתוג, נשלחים מגרמניה.משלוח חינם ומבוטח מעל 399 $. השער שלך ננעל ל-30 דקות מרגע פתיחת הקופה.שער נעול ל-30 דקות. כל פריט אטום, המספר הסידורי שלו נבדק, והוא מכוסה באחריות ל-24 חודשים.אטום, באחריות ל-24 חודשים.
RIMLANCE
An 8 GB dual-channel DDR3 kit running at 1333 MHz with CL9 latency and 1.5 V operation
This 8GB kit contains two 4GB unbuffered DIMMs built for DDR3 desktop platforms. It targets users who need a straightforward capacity increase for everyday multitasking and office workloads. The modules use major-brand chips selected for broad compatibility with standard motherboards. Installation requires only slotting the sticks into available memory sockets.
The kit runs at the standard 1.5V DDR3 voltage with a 1333MHz clock and PC3-10600 rating. At this voltage and speed the modules draw modest power and produce minimal heat under normal loads. CL9 latency keeps response times tight for typical desktop tasks. No active cooling is required for stock operation.
The unbuffered 2RX8 design works without manual BIOS tuning on most supporting boards. There is no bundled software, lighting control or heat-spreader accessory included. The package delivers the two DIMMs only, letting the system auto-detect timings at boot. This keeps the upgrade process simple for non-technical users.
| Brand | RIMLANCE |
|---|---|
| Model | RUD10600D8C2K8 |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
The kit uses the standard 240-pin DDR3 UDIMM form factor; check that your motherboard has DDR3 slots and supports 1333 MHz unbuffered non-ECC memory.
CL9 at 1333 MHz is the standard JEDEC timing for PC3-10600 and provides responsive performance for everyday desktop workloads.
Yes, 1.5 V is the standard operating voltage for DDR3 UDIMMs, so no special voltage settings are needed on compatible boards.
גם במדף הזה
אותו מדף, אותה קופה — שמונה מטבעות קריפטו ונעילת שער ל-30 דקות.
באיזה מטבע משלמים, ובאיזה מטבע מוצגים המחירים.
נשלח מהארנק שלך בקופה
לתצוגה בלבד — הקטלוג מתומחר בדולר ארה״ב
לא נמצא מטבע מתאים.
בחר את השפה שבה האתר פונה אליך.
אף שפה לא תואמת.
חדש כאן?
כבר יש לך חשבון?
אין כאן איפוס אוטומטי: החנות הזו לא שולחת אימייל, ולכן אין קישור חד-פעמי לבקש. השאר את הכתובת בחשבון, והיא תטופל ידנית.
הבקשה נקלטה
שום דבר לא בדרך לתיבת האימייל שלך — החנות הזו לא שולחת אימייל בכלל. מישהו אוסף את הבקשות האלה ידנית.
נזכרת בה?