NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
SAMSUNG
32 GB DDR4-2933 ECC registered dual-rank module with CL21 latency for stable server workloads
This module delivers 32GB of DDR4-2933 memory with CL21 latency in a registered dual-rank design. The onboard register reduces electrical load on the memory controller, allowing stable operation when multiple modules are populated. It targets workstations and servers that require error-correcting code protection for data integrity.
The registered architecture buffers address and command signals, which lowers the per-module load on the memory bus and helps maintain signal integrity at higher population counts. Dual-rank organisation increases density per slot, so fewer modules are needed to reach large system capacities. Standard 288-pin DIMM form factor fits desktop and server boards that support registered ECC memory.
On-die error-correcting code detects and corrects single-bit errors, reducing the risk of silent data corruption in critical workloads. Samsung’s DDR4 process delivers doubled bandwidth with reduced voltage compared with earlier generations, improving performance per watt. Enhanced RAS features further strengthen reliability and signal integrity for continuous operation.
| Brand | SAMSUNG |
|---|---|
| Capacity | 32GB |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
The module is rated for DDR4-2933 at CL21; the memory controller must support that speed and the registered design, otherwise it will down-clock to the highest JEDEC speed the platform allows.
It uses the standard DDR4 288-pin RDIMM form factor, so it physically fits any desktop DDR4 slot, but the motherboard must support registered ECC memory or the module will not be recognised.
Power off, open the retention clips, align the notch with the key, press firmly until both clips click, then enable ECC and registered mode in BIOS — skipping the BIOS step is the common mistake.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?