NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
A-Tech
32 GB DDR4 2400 ECC LRDIMM 2Rx4 server memory with 1.2 V operation and CL17 latency
This module delivers 32GB of DDR4 memory at 2400MHz with ECC and load-reduced buffering. It targets administrators upgrading compatible server or workstation platforms that require registered memory. The 2Rx4 organisation and 1.20V operation match the Samsung M386A4K40BB0-CRC and M386A4K40BB0-CRC5 part numbers. Builders needing unbuffered or non-ECC DIMMs should select a different product.
The load-reduced architecture reduces electrical loading on the memory bus, helping maintain signal integrity when all slots are populated. ECC detects and corrects single-bit errors during continuous operation. CL17 latency at PC4-19200 provides consistent throughput for virtualisation, database and compute workloads that run for extended periods. Systems not qualified for LRDIMM will not benefit from this module.
This 32GB stick replaces lower-capacity DDR4 LRDIMMs or non-ECC DIMMs in qualified platforms, doubling density per slot. The jump is worthwhile when the motherboard supports LRDIMM and the workload demands ECC protection at higher memory density. Buyers whose systems only accept standard RDIMM or UDIMM cannot use this module and must choose the correct form factor.
| Brand | A-Tech |
|---|---|
| Capacity | 32GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Load Reduced |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
The module runs at the standard DDR4 voltage of 1.20 V, so power draw and heat output stay within the normal range for registered server DIMMs at this speed.
You need a server or workstation board with DDR4 288-pin DIMM slots that explicitly support Load Reduced ECC memory; consumer desktop chipsets will not work.
Mixing Load Reduced and standard Registered DIMMs is not supported; all slots must use the same memory architecture for the system to boot and run stably.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?