NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
32 GB DDR4 2400 ECC LRDIMM 2Rx4 server memory with 1.2 V operation and CL17 latency
This module delivers 32GB of DDR4 memory at 2400MHz with ECC and load-reduced buffering. It targets administrators upgrading compatible server or workstation platforms that require registered memory. The 2Rx4 organisation and 1.20V operation match the Samsung M386A4K40BB0-CRC and M386A4K40BB0-CRC5 part numbers. Builders needing unbuffered or non-ECC DIMMs should select a different product.
The load-reduced architecture reduces electrical loading on the memory bus, helping maintain signal integrity when all slots are populated. ECC detects and corrects single-bit errors during continuous operation. CL17 latency at PC4-19200 provides consistent throughput for virtualisation, database and compute workloads that run for extended periods. Systems not qualified for LRDIMM will not benefit from this module.
This 32GB stick replaces lower-capacity DDR4 LRDIMMs or non-ECC DIMMs in qualified platforms, doubling density per slot. The jump is worthwhile when the motherboard supports LRDIMM and the workload demands ECC protection at higher memory density. Buyers whose systems only accept standard RDIMM or UDIMM cannot use this module and must choose the correct form factor.
| Brand | A-Tech |
|---|---|
| Capacity | 32GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Load Reduced |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
The module runs at the standard DDR4 voltage of 1.20 V, so power draw and heat output stay within the normal range for registered server DIMMs at this speed.
You need a server or workstation board with DDR4 288-pin DIMM slots that explicitly support Load Reduced ECC memory; consumer desktop chipsets will not work.
Mixing Load Reduced and standard Registered DIMMs is not supported; all slots must use the same memory architecture for the system to boot and run stably.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?