NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
A-Tech
32 GB DDR4 2400 ECC LRDIMM 2Rx4 server memory with 1.2 V operation and CL17 latency
This module delivers 32GB of DDR4 memory at 2400MHz with ECC and load-reduced buffering. It targets administrators upgrading compatible server or workstation platforms that require registered memory. The 2Rx4 organisation and 1.20V operation match the Samsung M386A4K40BB0-CRC and M386A4K40BB0-CRC5 part numbers. Builders needing unbuffered or non-ECC DIMMs should select a different product.
The load-reduced architecture reduces electrical loading on the memory bus, helping maintain signal integrity when all slots are populated. ECC detects and corrects single-bit errors during continuous operation. CL17 latency at PC4-19200 provides consistent throughput for virtualisation, database and compute workloads that run for extended periods. Systems not qualified for LRDIMM will not benefit from this module.
This 32GB stick replaces lower-capacity DDR4 LRDIMMs or non-ECC DIMMs in qualified platforms, doubling density per slot. The jump is worthwhile when the motherboard supports LRDIMM and the workload demands ECC protection at higher memory density. Buyers whose systems only accept standard RDIMM or UDIMM cannot use this module and must choose the correct form factor.
| Brand | A-Tech |
|---|---|
| Capacity | 32GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Load Reduced |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
The module runs at the standard DDR4 voltage of 1.20 V, so power draw and heat output stay within the normal range for registered server DIMMs at this speed.
You need a server or workstation board with DDR4 288-pin DIMM slots that explicitly support Load Reduced ECC memory; consumer desktop chipsets will not work.
Mixing Load Reduced and standard Registered DIMMs is not supported; all slots must use the same memory architecture for the system to boot and run stably.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?