Dogfish Technology mSATA 60GB internal SSD
- Internal Solid Stat…
- Consumer
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
Dogfish Technology
A 120 GB mSATA internal SSD with 3D NAND and SATA interface delivering up to 500 MB/s read and 420 MB/s write speeds
Options 120GB mSATA
The Dogfish Technology mSATA-120GB is an internal solid state drive with a 120GB capacity and an mSATA form factor. It uses 3D NAND flash memory and connects through a SATA III 6 Gb/s interface. The drive is intended for consumer desktop and laptop upgrades where an mSATA slot is available.
The drive measures 30mm by 50mm and fits standard mSATA slots. Installation requires only inserting the module into the slot and securing it with the board screw. Ensure the system BIOS recognises the SATA III interface; some older platforms may need a firmware update to boot from the drive. The controller supports TRIM, NCQ and DevSleep for standard operating system integration.
Sequential read reaches up to 500 MBps and sequential write up to 420 MBps according to the specification sheet. The SMI controller includes ECC, bad block management and wear levelling to maintain consistent throughput during extended writes. Operating temperature range is 0°C to 75°C, so adequate chassis airflow is advisable for prolonged heavy workloads.
| Brand | THREE COLOUR DOGFISH |
|---|---|
| Series | mSATA-120GB |
| Model | mSATA-120GB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | mSATA |
| Capacity | 120GB |
| Memory Components | 3D NAND |
| Interface | SATA III |
| Controller | SMI |
| Max Sequential Read | Up to 500 MBps |
| Max Sequential Write | Up to 420 MBps |
| MTBF | 1,000,000 hours |
| Operating Temperature | 0°C ~ +75°C |
| Storage Temperature | -45°C ~ +85°C |
| Operating Humidity | 0% ~ 95% |
| Height | 30mm |
| Width | 50mm |
| Depth | 1mm |
| Weight | 7g |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
Run a SATA benchmark tool such as CrystalDiskMark and compare the sequential read result to the 500 MB/s specification; the drive should reach that figure when connected to a SATA III port.
The package contains only the 30 x 50.9 mm mSATA module; you must supply a compatible mSATA slot and any mounting screw required by your laptop or desktop.
Select the 120 GB variant listed as mSATA-120GB; it delivers the stated 500 MB/s sequential read and 420 MB/s sequential write using 3D NAND flash.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?