Dogfish Technology mSATA 60GB internal SSD
- Internal Solid Stat…
- Consumer
Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.
Dogfish Technology
A 120 GB mSATA internal SSD with 3D NAND and SATA interface delivering up to 500 MB/s read and 420 MB/s write speeds
Options 120GB mSATA
The Dogfish Technology mSATA-120GB is an internal solid state drive with a 120GB capacity and an mSATA form factor. It uses 3D NAND flash memory and connects through a SATA III 6 Gb/s interface. The drive is intended for consumer desktop and laptop upgrades where an mSATA slot is available.
The drive measures 30mm by 50mm and fits standard mSATA slots. Installation requires only inserting the module into the slot and securing it with the board screw. Ensure the system BIOS recognises the SATA III interface; some older platforms may need a firmware update to boot from the drive. The controller supports TRIM, NCQ and DevSleep for standard operating system integration.
Sequential read reaches up to 500 MBps and sequential write up to 420 MBps according to the specification sheet. The SMI controller includes ECC, bad block management and wear levelling to maintain consistent throughput during extended writes. Operating temperature range is 0°C to 75°C, so adequate chassis airflow is advisable for prolonged heavy workloads.
| Brand | THREE COLOUR DOGFISH |
|---|---|
| Series | mSATA-120GB |
| Model | mSATA-120GB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | mSATA |
| Capacity | 120GB |
| Memory Components | 3D NAND |
| Interface | SATA III |
| Controller | SMI |
| Max Sequential Read | Up to 500 MBps |
| Max Sequential Write | Up to 420 MBps |
| MTBF | 1,000,000 hours |
| Operating Temperature | 0°C ~ +75°C |
| Storage Temperature | -45°C ~ +85°C |
| Operating Humidity | 0% ~ 95% |
| Height | 30mm |
| Width | 50mm |
| Depth | 1mm |
| Weight | 7g |
Další verze tohoto modelu
Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.
Run a SATA benchmark tool such as CrystalDiskMark and compare the sequential read result to the 500 MB/s specification; the drive should reach that figure when connected to a SATA III port.
The package contains only the 30 x 50.9 mm mSATA module; you must supply a compatible mSATA slot and any mounting screw required by your laptop or desktop.
Select the 120 GB variant listed as mSATA-120GB; it delivers the stated 500 MB/s sequential read and 420 MB/s sequential write using 3D NAND flash.
Také v této kategorii
Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.
Měna, ve které platíte, a měna, ve které se zobrazují ceny.
Odesláno z vaší peněženky u pokladny
Pouze pro zobrazení — katalog je veden v dolarech
Žádná měna neodpovídá.
Vyberte jazyk, ve kterém s vámi bude web komunikovat.
Poprvé tady?
Už účet máte?
Neexistuje žádná automatická obnova hesla: tento obchod neposílá žádné e-maily, takže neexistuje jednorázový odkaz, o který by bylo možné požádat. Nechte adresu uvedenou u účtu, vyřídíme ji ručně.
Žádost zaznamenána
Do vaší schránky nic nedorazí — tento obchod neposílá žádné e-maily. Někdo se o to postará ručně.
Vzpomněli jste si?