OWC 16GB DDR4 2400MHz CL17 1.2V 288pin ECC RDIMM Server memory upgrade
- 16GB
- 288-Pin DDR4 ECC RD…
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
OWC
16 GB DDR4 ECC registered RDIMM at 2400 MHz CL17 for Dell PowerEdge R930, T430 and R630XL servers
This 16 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.2 V operation. It uses a 288-pin registered ECC design built for Dell PowerEdge R930, T430 and R630XL servers. The 2Rx8 organisation provides error correction and signal buffering required by those platforms.
The module directly replaces Dell part numbers A8711887, A8797578 and SNPHNDJ7C/16G in the listed PowerEdge models. It upgrades systems running slower DDR4 or fills empty slots to increase total capacity. The jump is worth it when ECC registered memory is mandated by the server board and unbuffered DIMMs will not post.
This memory suits IT teams extending the service life of compatible Dell PowerEdge servers or building new configurations that require registered ECC DIMMs. It is not for desktop PCs, workstations that accept only unbuffered memory, or any system outside the three validated PowerEdge models.
| Brand | OWC |
|---|---|
| Part Number | 2R4D42R816GB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R930 Dell PowerEdge T430 Dell PowerEdge R630XL |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
This module uses the standard 288-pin DDR4 RDIMM form factor and installs directly into the DDR4 DIMM slots on the R930, T430 or R630XL motherboard.
Power down the server, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify in BIOS that the new 16 GB appears at 2400 MHz.
The module carries a limited lifetime warranty and is built to JEDEC and RoHS standards; replace only if memory diagnostics report correctable or uncorrectable ECC errors.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?