OWC 16GB DDR4 2400MHz CL17 1.2V 288pin ECC RDIMM Server memory upgrade
- 16GB
- 288-Pin DDR4 ECC RD…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
OWC
16 GB DDR4 ECC registered RDIMM at 2400 MHz CL17 for Dell PowerEdge R930, T430 and R630XL servers
This 16 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.2 V operation. It uses a 288-pin registered ECC design built for Dell PowerEdge R930, T430 and R630XL servers. The 2Rx8 organisation provides error correction and signal buffering required by those platforms.
The module directly replaces Dell part numbers A8711887, A8797578 and SNPHNDJ7C/16G in the listed PowerEdge models. It upgrades systems running slower DDR4 or fills empty slots to increase total capacity. The jump is worth it when ECC registered memory is mandated by the server board and unbuffered DIMMs will not post.
This memory suits IT teams extending the service life of compatible Dell PowerEdge servers or building new configurations that require registered ECC DIMMs. It is not for desktop PCs, workstations that accept only unbuffered memory, or any system outside the three validated PowerEdge models.
| Brand | OWC |
|---|---|
| Part Number | 2R4D42R816GB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R930 Dell PowerEdge T430 Dell PowerEdge R630XL |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
This module uses the standard 288-pin DDR4 RDIMM form factor and installs directly into the DDR4 DIMM slots on the R930, T430 or R630XL motherboard.
Power down the server, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify in BIOS that the new 16 GB appears at 2400 MHz.
The module carries a limited lifetime warranty and is built to JEDEC and RoHS standards; replace only if memory diagnostics report correctable or uncorrectable ECC errors.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?