OWC 16GB DDR4 2400MHz CL17 1.2V 288pin ECC RDIMM Server memory upgrade
- 16GB
- 288-Pin DDR4 ECC RD…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
16 GB DDR4 ECC registered RDIMM at 2400 MHz CL17 for Dell PowerEdge R930, T430 and R630XL servers
This 16 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.2 V operation. It uses a 288-pin registered ECC design built for Dell PowerEdge R930, T430 and R630XL servers. The 2Rx8 organisation provides error correction and signal buffering required by those platforms.
The module directly replaces Dell part numbers A8711887, A8797578 and SNPHNDJ7C/16G in the listed PowerEdge models. It upgrades systems running slower DDR4 or fills empty slots to increase total capacity. The jump is worth it when ECC registered memory is mandated by the server board and unbuffered DIMMs will not post.
This memory suits IT teams extending the service life of compatible Dell PowerEdge servers or building new configurations that require registered ECC DIMMs. It is not for desktop PCs, workstations that accept only unbuffered memory, or any system outside the three validated PowerEdge models.
| Brand | OWC |
|---|---|
| Part Number | 2R4D42R816GB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R930 Dell PowerEdge T430 Dell PowerEdge R630XL |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
This module uses the standard 288-pin DDR4 RDIMM form factor and installs directly into the DDR4 DIMM slots on the R930, T430 or R630XL motherboard.
Power down the server, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify in BIOS that the new 16 GB appears at 2400 MHz.
The module carries a limited lifetime warranty and is built to JEDEC and RoHS standards; replace only if memory diagnostics report correctable or uncorrectable ECC errors.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?