Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green printed circuit board with black memory chips and gold edge connector

OWC

OWC 2R4D42R816GB 16GB DDR4 2400MHz PC4-19200 CL17 1.2V 288pin ECC Registered RDIMM memory upgrade

SKU CH-552K-QN31K

16 GB DDR4 2400 MHz ECC registered RDIMM for Supermicro K1SPE, K1SPi, X10DAC, X10DAi and X10DAL-i motherboards

  • Capacity16GB
  • Type288-Pin DDR4 ECC RDIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.2V
  • ECCYes
  • ECC registered design prevents data corruption in servers
  • 16 GB capacity expands memory for demanding workloads
  • DDR4 2400 MHz speed matches PC4-19200 system requirements
  • 2 V operation reduces power draw in dense configurations
  • Validated for Supermicro K1SPE, K1SPi, X10DAC, X10DAi, X10DAL-i motherboards

Server ECC RDIMM upgrade

This 16GB DDR4 2400MHz registered DIMM adds ECC error correction to Supermicro motherboards K1SPE K1SPi X10DAC X10DAi and X10DAL-i. It runs at PC4 19200 with CL17 latency and 1.2V operation. The module is built for server and workstation workloads that require data integrity.

Simple slot installation

Align the 288-pin edge connector with the motherboard DIMM slot and press until the retention clips click. The registered buffer adds electrical load so the board must support registered memory. Mixing this module with unbuffered DIMMs will prevent the system from posting.

Verify registered ECC support

Check that your Supermicro board lists registered ECC RDIMMs in its qualified vendor list. The CPU and chipset must both support ECC and registered operation. Systems that only accept unbuffered non-ECC memory cannot use this upgrade.

Kohokohdat

  • ECC registered design prevents data corruption in servers
  • 16 GB capacity expands memory for demanding workloads
  • DDR4 2400 MHz speed matches PC4-19200 system requirements
  • 2 V operation reduces power draw in dense configurations
  • Validated for Supermicro K1SPE, K1SPi, X10DAC, X10DAi, X10DAL-i motherboards

Tekniset tiedot

BrandOWC
Part Number2R4D42R816GB
Capacity16GB
Type288-Pin DDR4 ECC RDIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.2V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
Heat SpreaderNo
Compatible SystemSupermicro Motherboard K1SPE
Supermicro Motherboard K1SPi
Supermicro Motherboard X10DAC
Supermicro Motherboard X10DAi
Supermicro Motherboard X10DAL-i

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I confirm the 16GB DDR4 2400MHz CL17 RDIMM is running at PC4-19200 after installation?

Enter the system BIOS or UEFI and verify the memory speed reads 2400 MT/s with CL17 timings at 1.2V; the module will report as ECC Registered and 2Rx8 in the SPD table.

What ships with the OWC 2R4D42R816GB module and what must I source separately?

The box contains the single 16GB 288-pin DDR4 ECC Registered RDIMM; no heat spreader, cables or tools are included, and any additional DIMMs for multi-channel population must be purchased separately.

Which capacity and rank option should I choose for a Supermicro X10DAi that supports 2Rx8 Registered ECC?

Select this 16GB 2Rx8 DDR4-2400 CL17 Registered ECC RDIMM; it matches the Supermicro part numbers MEMDR416LCL06ER24, MEMDR416LHL03ER24 and MEMDR416LSV01ER24 listed for the X10DAi, K1SPE, K1SPi, X10DAC and X10DAL-i boards.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.