NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
SAMSUNG
16 GB DDR4-2133 ECC server memory module with CL15 latency and 1.2 V operation
This 16 GB DDR4 module operates at 2133 MT/s with a CAS latency of CL15. It is built for servers and workstations that require error-correcting code memory for data integrity. The dual-rank 2Rx8 organisation uses Samsung chips on a 288-pin UDIMM. It suits administrators upgrading or repairing compatible DDR4 platforms.
The module runs at the standard DDR4 voltage of 1.20 V, keeping power consumption low in normal server operation. As an unbuffered DIMM without a register, it presents a lighter electrical load per channel than registered alternatives. Passive cooling via chassis airflow is sufficient; no active cooling or heatsink is included or required for typical use.
On-board ECC detects and corrects single-bit errors, reducing the risk of silent data corruption in critical workloads. The dual-rank 2Rx8 layout allows the memory controller to interleave accesses across ranks, which can improve bandwidth utilisation on supported platforms. Buyers who need registered DIMMs or higher capacities per module should verify platform requirements before purchase.
| Brand | SAMSUNG |
|---|---|
| Model | M391A2K43BB1-CPB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Align the notch on the 288-pin edge connector with the slot key, press down firmly until both retention clips click, then verify the system registers 16GB at DDR4 2133 in BIOS.
No routine maintenance is required; if a correctable error count rises or the module fails memtest, replace the 16GB stick with an identical 2Rx8 CL15 part.
The CL15 timing at 1.20V sets the latency floor; sustained throughput is capped by the DDR4 2133 bus before thermal throttling becomes a factor.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?