NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
SAMSUNG
16 GB DDR4-2133 ECC server memory module with CL15 latency and 1.2 V operation
This 16 GB DDR4 module operates at 2133 MT/s with a CAS latency of CL15. It is built for servers and workstations that require error-correcting code memory for data integrity. The dual-rank 2Rx8 organisation uses Samsung chips on a 288-pin UDIMM. It suits administrators upgrading or repairing compatible DDR4 platforms.
The module runs at the standard DDR4 voltage of 1.20 V, keeping power consumption low in normal server operation. As an unbuffered DIMM without a register, it presents a lighter electrical load per channel than registered alternatives. Passive cooling via chassis airflow is sufficient; no active cooling or heatsink is included or required for typical use.
On-board ECC detects and corrects single-bit errors, reducing the risk of silent data corruption in critical workloads. The dual-rank 2Rx8 layout allows the memory controller to interleave accesses across ranks, which can improve bandwidth utilisation on supported platforms. Buyers who need registered DIMMs or higher capacities per module should verify platform requirements before purchase.
| Brand | SAMSUNG |
|---|---|
| Model | M391A2K43BB1-CPB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Align the notch on the 288-pin edge connector with the slot key, press down firmly until both retention clips click, then verify the system registers 16GB at DDR4 2133 in BIOS.
No routine maintenance is required; if a correctable error count rises or the module fails memtest, replace the 16GB stick with an identical 2Rx8 CL15 part.
The CL15 timing at 1.20V sets the latency floor; sustained throughput is capped by the DDR4 2133 bus before thermal throttling becomes a factor.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?