NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
SAMSUNG
16 GB DDR4-2133 ECC server memory module with CL15 latency and 1.2 V operation
This 16 GB DDR4 module operates at 2133 MT/s with a CAS latency of CL15. It is built for servers and workstations that require error-correcting code memory for data integrity. The dual-rank 2Rx8 organisation uses Samsung chips on a 288-pin UDIMM. It suits administrators upgrading or repairing compatible DDR4 platforms.
The module runs at the standard DDR4 voltage of 1.20 V, keeping power consumption low in normal server operation. As an unbuffered DIMM without a register, it presents a lighter electrical load per channel than registered alternatives. Passive cooling via chassis airflow is sufficient; no active cooling or heatsink is included or required for typical use.
On-board ECC detects and corrects single-bit errors, reducing the risk of silent data corruption in critical workloads. The dual-rank 2Rx8 layout allows the memory controller to interleave accesses across ranks, which can improve bandwidth utilisation on supported platforms. Buyers who need registered DIMMs or higher capacities per module should verify platform requirements before purchase.
| Brand | SAMSUNG |
|---|---|
| Model | M391A2K43BB1-CPB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Align the notch on the 288-pin edge connector with the slot key, press down firmly until both retention clips click, then verify the system registers 16GB at DDR4 2133 in BIOS.
No routine maintenance is required; if a correctable error count rises or the module fails memtest, replace the 16GB stick with an identical 2Rx8 CL15 part.
The CL15 timing at 1.20V sets the latency floor; sustained throughput is capped by the DDR4 2133 bus before thermal throttling becomes a factor.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?