NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
SAMSUNG
16 GB DDR4-2133 ECC server memory module with CL15 latency and 1.2 V operation
This 16 GB DDR4 module operates at 2133 MT/s with a CAS latency of CL15. It is built for servers and workstations that require error-correcting code memory for data integrity. The dual-rank 2Rx8 organisation uses Samsung chips on a 288-pin UDIMM. It suits administrators upgrading or repairing compatible DDR4 platforms.
The module runs at the standard DDR4 voltage of 1.20 V, keeping power consumption low in normal server operation. As an unbuffered DIMM without a register, it presents a lighter electrical load per channel than registered alternatives. Passive cooling via chassis airflow is sufficient; no active cooling or heatsink is included or required for typical use.
On-board ECC detects and corrects single-bit errors, reducing the risk of silent data corruption in critical workloads. The dual-rank 2Rx8 layout allows the memory controller to interleave accesses across ranks, which can improve bandwidth utilisation on supported platforms. Buyers who need registered DIMMs or higher capacities per module should verify platform requirements before purchase.
| Brand | SAMSUNG |
|---|---|
| Model | M391A2K43BB1-CPB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Align the notch on the 288-pin edge connector with the slot key, press down firmly until both retention clips click, then verify the system registers 16GB at DDR4 2133 in BIOS.
No routine maintenance is required; if a correctable error count rises or the module fails memtest, replace the 16GB stick with an identical 2Rx8 CL15 part.
The CL15 timing at 1.20V sets the latency floor; sustained throughput is capped by the DDR4 2133 bus before thermal throttling becomes a factor.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?