BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
Syba
Converts an M.2 NVMe SSD to a 2.5-inch U.2 drive with SFF-8643 cable, PCIe 3.0 and NVM Express 1.2a support
This Syba adapter converts an M.2 M-key NVMe SSD into a 2.5-inch U.2 form factor. It targets builders who want to install an M.2 drive into a system bay or backplane that only accepts SFF-8639 connectors. The card supports PCI Express 3.0 and NVM Express 1.2a specifications. Operating system compatibility covers Windows 7 through 10 64-bit with UEFI 2.3.1 or later.
The adapter passes through the full performance of the installed M.2 NVMe drive without adding latency or bandwidth limits of its own. Maximum output current is rated at 3.3 volts and 5 amps, which accommodates most consumer and client SSDs. Short-circuit and thermal-shutdown protection circuits guard the drive and host against fault conditions. Builders needing higher power delivery or enterprise-grade power-loss protection should look elsewhere.
The package includes the adapter PCB, a copper mounting nut, two M3 screws of different lengths, two washers, and a SFF-8643 to U.2 adapter cable. These parts provide everything required to secure the M.2 drive onto the board and connect the assembly to a SFF-8643 port on a motherboard or HBA. No driver disc or management software is supplied.
| Brand | SYBA |
|---|---|
| Model | SI-ADA40123 |
| Type | M.2 PCIe I/F NVMe SSD to U.2 (SFF-8639) |
| Operating Systems Supported | Windows 7/8/8.1/10 64-Bit, UEFI 2.3.1 or later |
| Specifications | Built in M.2 M-Key Recep5cal Connector PCI Express Base Specifica5on Rev 3.0 NVM Express 1.2a 3.3v, 5A maximum output current Short Circuit Protec5on Thermal Shutdown Protec5on Windows 7/8/8.1/10 64-Bit |
| Features | This M.2 adapter turns a regular M.2 SSD drive into a U.2 SSD. The drive can then connect to SFF-8643 connector in the system via a SFF-8639 to U.2 cable, resulting in a drive with the same performance as it would be if it had been installed on a PCIe slot. |
| Package Contents | 1 x Adapter 1 x Copper Nut 1 x M3x3 Screw, M3x5 Screw 2 x Washers 1 x SFF-8643 to U.2 Adapter Cable |
| Szállítási súly | 0.15 kg |
| Csomagméret | 282 × 175 × 3 mm |
Yes, the adapter uses PCI Express Base Specification Rev 3.0, so it runs at PCIe 3.0 speeds when installed in a compatible motherboard slot.
The SSD should appear in UEFI 2.3.1 or later firmware and be recognised by Windows 7, 8, 8.1 or 10 64-Bit without additional drivers.
The box contains the adapter, a copper nut, M3x3 and M3x5 screws, two washers, and one SFF-8643 to U.2 adapter cable.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?