Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn

ABSKY

ABSKY X4-C 520Mh/s 240W mining hardware

SKU CH-SFNR-02C6X MPN X4-C

1U EtHash miner delivers 520 Mh/s at 240 W with a built-in quiet fan for rack or home use

  • Delivers 520Mh/s for EtHash mining
  • Consumes only 240W during full-load operation
  • Fits standard racks at 44.5mm 1U height
  • Runs quietly with built-in mute fan design
  • Operates reliably from 0 to 40 °C

EtHash miner for ETH and ETC

The ABSKY X4-C is a 1U server miner built for the EtHash algorithm. It delivers a maximum hashrate of 520Mh/s while drawing 240W. The unit fits a standard rack with dimensions of 482mm by 450mm by 44.5mm and weighs 8100g.

Operators with low-cost power and rack space

Suited for miners who run ETH or ETC on EtHash and need a quiet, rack-mountable device that operates between 0 and 40 °C at 5 to 95 % humidity. Not suited for algorithms other than EtHash or for coins that require more than the onboard 5G RAM capacity.

520Mh/s at 240W on EtHash

The single figure that decides fit is the 520Mh/s hashrate at 240W on the EtHash algorithm. If your target coin uses EtHash and the power budget matches, this unit meets the requirement; otherwise a different algorithm or efficiency class is needed.

Helstu kostir

  • Delivers 520Mh/s for EtHash mining
  • Consumes only 240W during full-load operation
  • Fits standard racks at 44.5mm 1U height
  • Runs quietly with built-in mute fan design
  • Operates reliably from 0 to 40 °C

Tæknilýsing

Engin birt tæknilýsing fyrir þessa vöru enn.

Spurningar um þessa vöru

Does the X4-C need any external controller or host computer to start mining?

The X4-C is a standalone 1U server miner; it runs the EtHash algorithm internally at up to 520Mh/s once powered and connected to a network, so no separate host is required.

Will the X4-C fit in the same rack space as my existing 1U gear?

The unit measures 482mm wide, 450mm deep and 44.5mm high, matching a standard 1U rack footprint, so it occupies the same vertical space as other 1U devices.

How can I confirm the X4-C is hashing at its rated 520Mh/s after setup?

Check the miner's dashboard or pool-side statistics; a stable reading near 520Mh/s with a power draw around 240W and temperatures staying within 0‑40 °C shows it is operating as specified.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.