Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

ABSKY

ABSKY X4-C 520Mh/s 240W mining hardware

SKU CH-SFNR-02C6X MPN X4-C

1U EtHash miner delivers 520 Mh/s at 240 W with a built-in quiet fan for rack or home use

  • Delivers 520Mh/s for EtHash mining
  • Consumes only 240W during full-load operation
  • Fits standard racks at 44.5mm 1U height
  • Runs quietly with built-in mute fan design
  • Operates reliably from 0 to 40 °C

EtHash miner for ETH and ETC

The ABSKY X4-C is a 1U server miner built for the EtHash algorithm. It delivers a maximum hashrate of 520Mh/s while drawing 240W. The unit fits a standard rack with dimensions of 482mm by 450mm by 44.5mm and weighs 8100g.

Operators with low-cost power and rack space

Suited for miners who run ETH or ETC on EtHash and need a quiet, rack-mountable device that operates between 0 and 40 °C at 5 to 95 % humidity. Not suited for algorithms other than EtHash or for coins that require more than the onboard 5G RAM capacity.

520Mh/s at 240W on EtHash

The single figure that decides fit is the 520Mh/s hashrate at 240W on the EtHash algorithm. If your target coin uses EtHash and the power budget matches, this unit meets the requirement; otherwise a different algorithm or efficiency class is needed.

Kohokohdat

  • Delivers 520Mh/s for EtHash mining
  • Consumes only 240W during full-load operation
  • Fits standard racks at 44.5mm 1U height
  • Runs quietly with built-in mute fan design
  • Operates reliably from 0 to 40 °C

Tekniset tiedot

Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.

Kysymyksiä tästä tuotteesta

Does the X4-C need any external controller or host computer to start mining?

The X4-C is a standalone 1U server miner; it runs the EtHash algorithm internally at up to 520Mh/s once powered and connected to a network, so no separate host is required.

Will the X4-C fit in the same rack space as my existing 1U gear?

The unit measures 482mm wide, 450mm deep and 44.5mm high, matching a standard 1U rack footprint, so it occupies the same vertical space as other 1U devices.

How can I confirm the X4-C is hashing at its rated 520Mh/s after setup?

Check the miner's dashboard or pool-side statistics; a stable reading near 520Mh/s with a power draw around 240W and temperatures staying within 0‑40 °C shows it is operating as specified.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.