Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR3 DIMM sticks without heat spreaders

Computer Memory Solutions

Computer Memory Solutions CM2566410600DIMM1R8 4GB (2x2GB) DDR3 1333 CL9 1.5V

SKU CH-ZTK9-N8H22

A 4 GB DDR3 kit (two 2 GB sticks) running at 1333 MHz CL9 1.5 V, validated for Gateway SX 2803 desktops

  • Capacity4GB (2 x 2GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 4GB dual-channel kit boosts multitasking on Gateway SX2803 desktops
  • DDR3 1333 MHz CL9 timing matches factory spec for stable operation
  • 5 V unbuffered non-ECC DIMMs install without BIOS changes
  • Two 2 GB modules fill both slots for maximum 8 GB support
  • Major-brand chips backed by manufacturer lifetime exchange warranty

Targeted DDR3 upgrade

This 4 GB kit contains two 2 GB DDR3-1333 modules built for Gateway SX2803 desktops. Unbuffered non-ECC DIMMs with CL9 timing install directly into the two available slots. Major-brand chips are tested for the listed models. No heat spreader is fitted.

Standard voltage operation

Each stick runs at the JEDEC 1.5 V specification for DDR3 1333. Unbuffered design keeps electrical load low on the memory controller. Passive cooling relies on case airflow; no fan or spreader adds noise. Power draw stays within normal DDR3 limits for this density.

System-specific compatibility

Guaranteed to work in Gateway SX2803-25E, SX2803-53 and SX2803-UB20P desktops. Maximum supported memory for these systems is 8 GB, so this 4 GB kit fills half the capacity. Buyers needing the full 8 GB limit or a different platform should look elsewhere.

Helstu kostir

  • 4GB dual-channel kit boosts multitasking on Gateway SX2803 desktops
  • DDR3 1333 MHz CL9 timing matches factory spec for stable operation
  • 5 V unbuffered non-ECC DIMMs install without BIOS changes
  • Two 2 GB modules fill both slots for maximum 8 GB support
  • Major-brand chips backed by manufacturer lifetime exchange warranty

Tæknilýsing

BrandComputer Memory Solutions
ModelCM2566410600DIMM1R8
Capacity4GB (2 x 2GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemGateway Sx Desktop Sx2803-25E Sx2803-53, Sx2803-Ub20P
Package Content2 Memory RAM Sticks

Spurningar um þessa vöru

How do I install the 240-pin DDR3 modules in my Gateway SX2803 desktop, and which step do people often miss?

Power off the system, open the chassis, align each 240-pin DIMM with the slot notch, press firmly until both side clips click, then verify the BIOS shows 4 GB at 1333 MHz. The step most often missed is seating both clips fully — one click is not enough.

What maintenance or replacement will this 2×2 GB DDR3 kit need over time?

No routine maintenance is required for unbuffered DDR3 DIMMs; keep interior dust-free and ensure case airflow stays adequate. Replacement is only needed if a module fails or you upgrade to the platform maximum of 8 GB using the two available slots.

What limit appears first when this CL9 1.5 V DDR3 memory runs under sustained load?

The primary limit is the fixed DDR3-1333 data rate and CL9 latency; bandwidth and timing cannot increase beyond the JEDEC PC3-10600 specification, so throughput caps at that level regardless of workload duration.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.