We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two green DDR3 DIMM sticks without heat spreaders

Computer Memory Solutions

Computer Memory Solutions CM2566410600DIMM1R8 4GB (2x2GB) DDR3 1333 CL9 1.5V

SKU CH-ZTK9-N8H22

A 4 GB DDR3 kit (two 2 GB sticks) running at 1333 MHz CL9 1.5 V, validated for Gateway SX 2803 desktops

  • Capacity4GB (2 x 2GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 4GB dual-channel kit boosts multitasking on Gateway SX2803 desktops
  • DDR3 1333 MHz CL9 timing matches factory spec for stable operation
  • 5 V unbuffered non-ECC DIMMs install without BIOS changes
  • Two 2 GB modules fill both slots for maximum 8 GB support
  • Major-brand chips backed by manufacturer lifetime exchange warranty

Targeted DDR3 upgrade

This 4 GB kit contains two 2 GB DDR3-1333 modules built for Gateway SX2803 desktops. Unbuffered non-ECC DIMMs with CL9 timing install directly into the two available slots. Major-brand chips are tested for the listed models. No heat spreader is fitted.

Standard voltage operation

Each stick runs at the JEDEC 1.5 V specification for DDR3 1333. Unbuffered design keeps electrical load low on the memory controller. Passive cooling relies on case airflow; no fan or spreader adds noise. Power draw stays within normal DDR3 limits for this density.

System-specific compatibility

Guaranteed to work in Gateway SX2803-25E, SX2803-53 and SX2803-UB20P desktops. Maximum supported memory for these systems is 8 GB, so this 4 GB kit fills half the capacity. Buyers needing the full 8 GB limit or a different platform should look elsewhere.

Highlights

  • 4GB dual-channel kit boosts multitasking on Gateway SX2803 desktops
  • DDR3 1333 MHz CL9 timing matches factory spec for stable operation
  • 5 V unbuffered non-ECC DIMMs install without BIOS changes
  • Two 2 GB modules fill both slots for maximum 8 GB support
  • Major-brand chips backed by manufacturer lifetime exchange warranty

Specifications

BrandComputer Memory Solutions
ModelCM2566410600DIMM1R8
Capacity4GB (2 x 2GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemGateway Sx Desktop Sx2803-25E Sx2803-53, Sx2803-Ub20P
Package Content2 Memory RAM Sticks

Questions about this item

How do I install the 240-pin DDR3 modules in my Gateway SX2803 desktop, and which step do people often miss?

Power off the system, open the chassis, align each 240-pin DIMM with the slot notch, press firmly until both side clips click, then verify the BIOS shows 4 GB at 1333 MHz. The step most often missed is seating both clips fully — one click is not enough.

What maintenance or replacement will this 2×2 GB DDR3 kit need over time?

No routine maintenance is required for unbuffered DDR3 DIMMs; keep interior dust-free and ensure case airflow stays adequate. Replacement is only needed if a module fails or you upgrade to the platform maximum of 8 GB using the two available slots.

What limit appears first when this CL9 1.5 V DDR3 memory runs under sustained load?

The primary limit is the fixed DDR3-1333 data rate and CL9 latency; bandwidth and timing cannot increase beyond the JEDEC PC3-10600 specification, so throughput caps at that level regardless of workload duration.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.