Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Rectangular ATX power supply unit with single fan, matte metal finish, reduced depth design

Gulfe

Gulfe ATX Power Supply for HP Pavilion H8 1031NL 1034DE 1035CN

SKU CH-0P7K-0CY3E

ATX power supply replaces legacy units in HP Pavilion H8 desktops with 24-pin ATX, 4-pin CPU, three SATA and two LP4 connectors

  • TypeATX
  • Fans1
  • Weight2.5
  • Replaces legacy HP units with exact-fit ATX design
  • Dual-voltage 115/230 V input works worldwide
  • Over-current and over-power protection guards components
  • Reduced 5.9" depth fits compact chassis easily
  • 24-pin ATX plus 4-pin CPU and three SATA connectors

Targeted replacement

This ATX power supply is built to replace the original unit in HP Pavilion H8 1031NL, 1034DE and 1035CN desktops. Its reduced depth helps it fit the proprietary chassis without modification. The unit delivers the standard +5V, -5V, +12V1, +12V2, +3.3V, -12V and +5V-SB rails required by those systems.

Thermals and protection

A single fan provides airflow through the compact housing while over-current and over-power protection circuits guard connected components. The supplier notes high efficiency and low ripple and noise, with a rise time under 70 ms and a minimum hold-up time of 17 ms at nominal input. AC input accepts 115 or 230 V at 47 to 63 Hz.

Connector bundle

The fixed cable set includes a 24-pin ATX connector, one 4-pin P4 12V plug, three SATA 15-pin connectors, two LP4 4-pin plugs and one floppy 4-pin connector. This mix covers the motherboard, processor, drives and legacy peripherals found in the target HP models without needing adapters.

Helstu kostir

  • Replaces legacy HP units with exact-fit ATX design
  • Dual-voltage 115/230 V input works worldwide
  • Over-current and over-power protection guards components
  • Reduced 5.9" depth fits compact chassis easily
  • 24-pin ATX plus 4-pin CPU and three SATA connectors

Tæknilýsing

BrandGulfe
TypeATX
Fans1
Weight2.5

Spurningar um þessa vöru

How do I install the 24-pin ATX connector and the 4-pin P4 power cable without forcing them?

Align the 20+4 pin ATX connector with the motherboard keying and press until the latch clicks; then plug the P4 4-pin cable into the CPU power header, matching the square and rounded pins exactly.

Which parts of this power supply are most likely to need replacement after long-term use?

The single internal fan is the primary wear item; dust buildup on its blades reduces airflow, so plan to clean or replace the fan if noise or temperatures rise.

What is the first limit reached when the unit runs at full load continuously?

The 17 ms minimum hold-up time at nominal input is the first hard limit; if mains power dips longer than that, output voltage will drop before the protection circuits act.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.