Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green circuit board with black memory chips and gold contacts

Kingston Technology Corp.

Kingston Technology Corp. KVR16R11S4/4I 4GB DDR3-1600 ECC Registered CL11 1.5V desktop RAM

SKU CH-19NZ-F2PXS

4 GB DDR3 module running at 1600 MHz with ECC, registered buffering and CL11 latency

  • ECC protection for data integrity with registered DDR3 design
  • 1600 MHz speed meets PC3-12800 bandwidth needs
  • 4 GB capacity in 512M x 72 single-rank layout
  • 5 V operation with thermal sensor for stable performance

Kingston DDR3-1600 ECC Registered Module

This 4 GB DDR3 module runs at 1600 MHz with a CL11 latency and 1.5 V operation. It uses a 240-pin registered design and includes an on-board thermal sensor. The single-rank x4 organisation is built for Intel-chip platforms that require error-correcting memory.

Suited for servers and workstations needing

Buyers who need unbuffered memory or a different voltage should look elsewhere. Systems that cannot accept registered DIMMs will not be compatible. This module does not support non-ECC or consumer desktop configurations.

Helstu kostir

  • ECC protection for data integrity with registered DDR3 design
  • 1600 MHz speed meets PC3-12800 bandwidth needs
  • 4 GB capacity in 512M x 72 single-rank layout
  • 5 V operation with thermal sensor for stable performance

Tæknilýsing

BrandKingston
ModelKVR16R11S4/4I

Spurningar um þessa vöru

Does my motherboard need 240-pin DDR3 slots that accept registered ECC modules to use this KVR16R11S4/4I stick?

Yes, this module uses a 240-pin DDR3 interface and is both ECC and registered, so the board must explicitly support registered ECC memory.

Can I run this CL11 1.5 V registered kit alongside older unbuffered non-ECC DDR3 DIMMs I already own?

No, registered and unbuffered DIMMs cannot be mixed on the same motherboard; the memory controller requires one type or the other.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.