Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
Green circuit board with black memory chips and gold contacts

Kingston Technology Corp.

Kingston Technology Corp. KVR16R11S4/4I 4GB DDR3-1600 ECC Registered CL11 1.5V desktop RAM

SKU CH-19NZ-F2PXS

4 GB DDR3 module running at 1600 MHz with ECC, registered buffering and CL11 latency

  • ECC protection for data integrity with registered DDR3 design
  • 1600 MHz speed meets PC3-12800 bandwidth needs
  • 4 GB capacity in 512M x 72 single-rank layout
  • 5 V operation with thermal sensor for stable performance

Kingston DDR3-1600 ECC Registered Module

This 4 GB DDR3 module runs at 1600 MHz with a CL11 latency and 1.5 V operation. It uses a 240-pin registered design and includes an on-board thermal sensor. The single-rank x4 organisation is built for Intel-chip platforms that require error-correcting memory.

Suited for servers and workstations needing

Buyers who need unbuffered memory or a different voltage should look elsewhere. Systems that cannot accept registered DIMMs will not be compatible. This module does not support non-ECC or consumer desktop configurations.

Høydepunkter

  • ECC protection for data integrity with registered DDR3 design
  • 1600 MHz speed meets PC3-12800 bandwidth needs
  • 4 GB capacity in 512M x 72 single-rank layout
  • 5 V operation with thermal sensor for stable performance

Spesifikasjoner

BrandKingston
ModelKVR16R11S4/4I

Spørsmål om denne varen

Does my motherboard need 240-pin DDR3 slots that accept registered ECC modules to use this KVR16R11S4/4I stick?

Yes, this module uses a 240-pin DDR3 interface and is both ECC and registered, so the board must explicitly support registered ECC memory.

Can I run this CL11 1.5 V registered kit alongside older unbuffered non-ECC DDR3 DIMMs I already own?

No, registered and unbuffered DIMMs cannot be mixed on the same motherboard; the memory controller requires one type or the other.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.