Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
myVolts replacement power supply unit with 10-pin connector

myVolts

myVolts Power Supply for HK280-72PP PA-2181-2 PCG010 FSP180-20TGBAB 10-pin

SKU CH-7R94-Q70FC

Replacement AT power supply with 10-pin connector for compatible systems

  • TypeAT
  • Compatible with HK280-72PP, PA-2181-2, PCG010 and FSP180-20TGBAB models
  • 10-pin connector ensures correct fit for listed power supplies
  • AT-type design matches original specification for reliable operation
  • New condition guarantees full performance from first use

Targeted AT Replacement

This myVolts unit is a direct-fit AT power supply built for the HK280-72PP PA-2181-2 PCG010 FSP180-20TGBAB 10-pin chassis. It serves technicians and hobbyists restoring or maintaining legacy systems that require this exact pin-out and form factor.

Upgrade From Failed OEM

The module replaces a failed or ageing original supply in the same enclosure without rewiring. The jump is worth it when the existing unit no longer holds voltage under load or when a spare is needed for preventive maintenance on matched hardware.

Helstu kostir

  • Compatible with HK280-72PP, PA-2181-2, PCG010 and FSP180-20TGBAB models
  • 10-pin connector ensures correct fit for listed power supplies
  • AT-type design matches original specification for reliable operation
  • New condition guarantees full performance from first use

Tæknilýsing

TypeAT

Spurningar um þessa vöru

What form factor does the 10-pin AT power supply use for mounting?

The unit follows the AT form factor and mounts using the standard AT screw pattern found on compatible chassis.

How is the 10-pin connector attached during installation, and what is the common mistake?

Align the keyed 10-pin plug with the motherboard header and press straight in; the frequent error is forcing it offset by one row, which bends pins.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.