Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
myVolts replacement power supply unit with 10-pin connector

myVolts

myVolts Power Supply for HK280-72PP PA-2181-2 PCG010 FSP180-20TGBAB 10-pin

SKU CH-7R94-Q70FC

Replacement AT power supply with 10-pin connector for compatible systems

  • TypeAT
  • Compatible with HK280-72PP, PA-2181-2, PCG010 and FSP180-20TGBAB models
  • 10-pin connector ensures correct fit for listed power supplies
  • AT-type design matches original specification for reliable operation
  • New condition guarantees full performance from first use

Targeted AT Replacement

This myVolts unit is a direct-fit AT power supply built for the HK280-72PP PA-2181-2 PCG010 FSP180-20TGBAB 10-pin chassis. It serves technicians and hobbyists restoring or maintaining legacy systems that require this exact pin-out and form factor.

Upgrade From Failed OEM

The module replaces a failed or ageing original supply in the same enclosure without rewiring. The jump is worth it when the existing unit no longer holds voltage under load or when a spare is needed for preventive maintenance on matched hardware.

Prednosti

  • Compatible with HK280-72PP, PA-2181-2, PCG010 and FSP180-20TGBAB models
  • 10-pin connector ensures correct fit for listed power supplies
  • AT-type design matches original specification for reliable operation
  • New condition guarantees full performance from first use

Špecifikácie

TypeAT

Otázky k tomuto produktu

What form factor does the 10-pin AT power supply use for mounting?

The unit follows the AT form factor and mounts using the standard AT screw pattern found on compatible chassis.

How is the 10-pin connector attached during installation, and what is the common mistake?

Align the keyed 10-pin plug with the motherboard header and press straight in; the frequent error is forcing it offset by one row, which bends pins.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.