Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn

myVolts

myVolts Replacement Power Supply HP A1700 A1705 A1710 A1712 420W

SKU CH-EQH6-80870

A reduced-depth 420 W AT power supply with 20+4-pin, SATA and Molex connectors for HP A1700, A1705, A1710 and A1712 desktops

  • TypeAT
  • 420 W peak output handles demanding desktop workloads
  • 280 W continuous rating delivers stable everyday power
  • 24-pin plus 4-pin CPU connectors fit modern motherboards
  • 3 SATA and 2 Molex plugs support multiple drives
  • 86" depth fits tight HP A1700 A1705 A1710 A1712 cases

Replacement PSU for HP Desktops

This myVolts power supply replaces the original units in HP A1700 A1705 A1710 and A1712 desktop models. It delivers up to 420 Watts maximum and 280 Watts total continuous power. The AT form factor fits a standard ATX slot with reduced depth for tighter chassis clearance.

420 Watt Peak with 280 Watt Continuous Rating

The single figure that decides compatibility is the 280 Watt total continuous output across +5 V -5 V +12 V1 +12 V2 +3.3 V -12 V and +5 V standby rails. If the original HP unit was rated higher than 280 Watts continuous this replacement may not sustain full system load.

Suits Direct HP Swaps Not High Power Builds

This unit suits owners of the listed HP desktops who need a like-for-like new replacement with 20+4 pin motherboard 4 pin CPU three SATA two Molex and one floppy connector. Builders needing more than 280 Watts continuous or modular cabling should look at higher rated ATX power supplies.

Helstu kostir

  • 420 W peak output handles demanding desktop workloads
  • 280 W continuous rating delivers stable everyday power
  • 24-pin plus 4-pin CPU connectors fit modern motherboards
  • 3 SATA and 2 Molex plugs support multiple drives
  • 86" depth fits tight HP A1700 A1705 A1710 A1712 cases

Tæknilýsing

TypeAT

Spurningar um þessa vöru

What does the 420 W maximum mean once the unit is installed?

The 420 W figure is the peak output the supply can deliver for short periods; continuous combined output across all rails is rated at 280 W, so sustained loads should stay within that lower total.

Which interface standard governs the drive power connectors and what does it limit?

The three SATA 15-pin connectors follow the SATA power specification, limiting each drive connector to the standard 3.3 V, 5 V and 12 V rails defined by that interface.

What physical space is needed to mount this supply in a case?

The unit measures 5.86" by 3.3" with reduced depth, so it fits a standard ATX mounting cut-out while leaving extra clearance behind the rear panel.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.