Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Two green DDR4 SODIMM sticks, 260-pin, no heat spreader

NEMIX RAM

NEMIX RAM 32GB (2x16GB) DDR4 3200 CL22 260-pin SODIMM POSIFLEX ZT-3115 memory upgrade

SKU CH-XT6D-M8KGX

A 32 GB kit of two 16 GB DDR4 3200 CL22 SODIMM modules for POSIFLEX ZT-3115 terminals

  • Capacity32GB (2 x 16GB)
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 32 GB kit expands POS terminal memory for smoother multitasking
  • 3200 MT/s DDR4 speed matches system bus for stable throughput
  • CL22 latency keeps response predictable under load
  • 20 V operation reduces heat in compact kiosk chassis
  • 260-pin SODIMM form factor fits POSIFLEX ZT-3115 slots directly

POSIFLEX ZT-3115 memory upgrade

This kit provides 32 GB of DDR4 3200 memory in two 16 GB SODIMM modules built for the POSIFLEX ZT-3115 Haydn ZT Series POS terminal. It runs at 1.2 V with CL22 latency and uses unbuffered non-ECC chips from major OEM suppliers. The 260-pin form factor matches the system's memory slots exactly.

Suits operators upgrading a ZT-3115 terminal

Installers who need the full 32 GB capacity supported by this model will use both slots. Buyers who only need a smaller capacity increase should look at a single-module kit. Systems that require ECC or registered memory cannot use this unbuffered non-ECC kit.

Fits the ZT-3115 without extra parts

The modules plug directly into the terminal's two SODIMM slots and draw standard DDR4 voltage. No heat spreader is included, so airflow inside the chassis handles cooling. Using both slots reaches the kit's 32 GB total and leaves no free slots for further expansion.

Helstu kostir

  • 32 GB kit expands POS terminal memory for smoother multitasking
  • 3200 MT/s DDR4 speed matches system bus for stable throughput
  • CL22 latency keeps response predictable under load
  • 20 V operation reduces heat in compact kiosk chassis
  • 260-pin SODIMM form factor fits POSIFLEX ZT-3115 slots directly

Tæknilýsing

BrandNEMIX RAM
SeriesPOSIFLEX POS Series Point of Sale Kiosk Memory
ModelPOSIFLEX POS DDR4 3200MHZ Non-ECC Unbuffered SODIMM
Part NumberMS25600-628K2
Capacity32GB (2 x 16GB)
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemPOSIFLEX POS
CAS LatencyCL22
Heat SpreaderNo
Type260-Pin DDR4 SODIMM
Rank2Rx8
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content32GB (2X16GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 260-PIN Non-ECC Unbuffered SODIMM KIT

Spurningar um þessa vöru

Does the POSIFLEX ZT-3115 terminal need two free 260-pin DDR4 SODIMM slots to use this 32GB kit?

Yes, the kit contains two 16GB modules that each occupy one 260-pin DDR4 SODIMM slot, so two empty slots are required.

Will these 1.20V CL22 DDR4 3200 modules down-clock if the ZT-3115 platform only supports a lower DDR4 speed?

The modules are rated for DDR4 3200 at 1.20V with CL22 and will run at the highest speed the POSIFLEX ZT-3115 memory controller allows, which may be lower than 3200.

How can I confirm the ZT-3115 recognises the full 32GB after installing the 2Rx8 modules?

Check the system BIOS or the operating-system memory report; both should show 32GB total and the DDR4 3200 speed if the platform supports it.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.