Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Single green 288-pin DDR4 UDIMM module without heat spreader, 32GB 3200 CL22 1.2V

NEMIX RAM

NEMIX RAM 32GB DDR4 3200 CL22 2Rx8 1.2V 288-Pin UDIMM SuperMicro SYS-530AD-I memory upgrade

SKU CH-8SBD-C7429

A 32 GB DDR4 3200 UDIMM module with CL22 timing and 1.2 V operation for the SuperMicro SYS-530AD-I workstation

  • Capacity32GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 32 GB capacity expands system memory for demanding workloads
  • DDR4 3200 speed transfers data at PC4-25600 bandwidth
  • CL22 latency with 1.2 V operation balances timing and efficiency
  • 2Rx8 dual-rank 288-pin UDIMM fits compatible SuperMicro SYS-530AD-I slots
  • Major OEM Samsung, Micron, Hynix chips tested under load for reliability

SuperMicro SYS-530AD-I upgrade

This 32 GB DDR4 module is built for the SuperMicro SYS-530AD-I desktop workstation. It adds a single 32 GB stick to increase total system memory for demanding workloads. The kit targets IT professionals and enthusiasts who need a validated, system-specific upgrade.

Unbuffered 288-pin UDIMM build

The stick uses a standard 288-pin UDIMM form factor without a heat spreader, keeping the profile low for tight chassis layouts. It runs at 1.2 V with CL22 latency and a 2Rx8 organisation, drawing minimal power while fitting any compatible UDIMM slot. Non-ECC unbuffered design means it installs like ordinary desktop memory.

Verify DDR4 UDIMM slot availability

Confirm the workstation has a free 288-pin DDR4 UDIMM slot and that the motherboard accepts non-ECC unbuffered modules at 3200 MT/s. The system must support 2Rx8 density and 1.2 V operation without requiring registered or ECC memory. Check the manual for maximum per-slot capacity before ordering.

Helstu kostir

  • 32 GB capacity expands system memory for demanding workloads
  • DDR4 3200 speed transfers data at PC4-25600 bandwidth
  • CL22 latency with 1.2 V operation balances timing and efficiency
  • 2Rx8 dual-rank 288-pin UDIMM fits compatible SuperMicro SYS-530AD-I slots
  • Major OEM Samsung, Micron, Hynix chips tested under load for reliability

Tæknilýsing

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ Non-ECC Unbuffered UDIMM
Part NumberMD25600-328K1
Capacity32GB
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 UDIMM
Rank2Rx8
FeaturesDDR4 Non- ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB (1X32GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 288-PIN Non-ECC Unbuffered UDIMM

Spurningar um þessa vöru

Does this DDR4-3200 PC4-25600 module run at its rated speed on the SuperMicro SYS-530AD-I?

The module is specified as DDR4 3200 PC4-25600 CL22 and is validated for the SuperMicro SYS-530AD-I workstation.

Will this 288-pin UDIMM fit the DIMM slots on the SYS-530AD-I?

The stick is a standard 288-pin DDR4 UDIMM with no heat spreader, matching the desktop DIMM slots on the SYS-530AD-I.

What is the correct way to seat this single 32 GB module in the workstation?

Power off, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify 32 GB appears in BIOS.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.