We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Single green 288-pin DDR4 UDIMM module without heat spreader, 32GB 3200 CL22 1.2V

NEMIX RAM

NEMIX RAM 32GB DDR4 3200 CL22 2Rx8 1.2V 288-Pin UDIMM SuperMicro SYS-530AD-I memory upgrade

SKU CH-8SBD-C7429

A 32 GB DDR4 3200 UDIMM module with CL22 timing and 1.2 V operation for the SuperMicro SYS-530AD-I workstation

  • Capacity32GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 32 GB capacity expands system memory for demanding workloads
  • DDR4 3200 speed transfers data at PC4-25600 bandwidth
  • CL22 latency with 1.2 V operation balances timing and efficiency
  • 2Rx8 dual-rank 288-pin UDIMM fits compatible SuperMicro SYS-530AD-I slots
  • Major OEM Samsung, Micron, Hynix chips tested under load for reliability

SuperMicro SYS-530AD-I upgrade

This 32 GB DDR4 module is built for the SuperMicro SYS-530AD-I desktop workstation. It adds a single 32 GB stick to increase total system memory for demanding workloads. The kit targets IT professionals and enthusiasts who need a validated, system-specific upgrade.

Unbuffered 288-pin UDIMM build

The stick uses a standard 288-pin UDIMM form factor without a heat spreader, keeping the profile low for tight chassis layouts. It runs at 1.2 V with CL22 latency and a 2Rx8 organisation, drawing minimal power while fitting any compatible UDIMM slot. Non-ECC unbuffered design means it installs like ordinary desktop memory.

Verify DDR4 UDIMM slot availability

Confirm the workstation has a free 288-pin DDR4 UDIMM slot and that the motherboard accepts non-ECC unbuffered modules at 3200 MT/s. The system must support 2Rx8 density and 1.2 V operation without requiring registered or ECC memory. Check the manual for maximum per-slot capacity before ordering.

Highlights

  • 32 GB capacity expands system memory for demanding workloads
  • DDR4 3200 speed transfers data at PC4-25600 bandwidth
  • CL22 latency with 1.2 V operation balances timing and efficiency
  • 2Rx8 dual-rank 288-pin UDIMM fits compatible SuperMicro SYS-530AD-I slots
  • Major OEM Samsung, Micron, Hynix chips tested under load for reliability

Specifications

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ Non-ECC Unbuffered UDIMM
Part NumberMD25600-328K1
Capacity32GB
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 UDIMM
Rank2Rx8
FeaturesDDR4 Non- ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB (1X32GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 288-PIN Non-ECC Unbuffered UDIMM

Questions about this item

Does this DDR4-3200 PC4-25600 module run at its rated speed on the SuperMicro SYS-530AD-I?

The module is specified as DDR4 3200 PC4-25600 CL22 and is validated for the SuperMicro SYS-530AD-I workstation.

Will this 288-pin UDIMM fit the DIMM slots on the SYS-530AD-I?

The stick is a standard 288-pin DDR4 UDIMM with no heat spreader, matching the desktop DIMM slots on the SYS-530AD-I.

What is the correct way to seat this single 32 GB module in the workstation?

Power off, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then verify 32 GB appears in BIOS.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.